Carson SC-407-10 - Manuals - manualsarea.com

Page 2 - AMPLIFIER INPUT POWER:; pounds; AMPLIFIER PROTECTION:; Stops high output power from blowing speaker; LIGHT CONTROL INPUT POWER:; NOTICE

TB0346A Page 2 of 12 05/07/05 SC-407-10 SPECIFICATIONS AMPLIFIER INPUT POWER: 9-16 Volts DC, 8 Amps DC per 100W Speaker SIREN MODE OUTPUT POWER: 15 VDC input, 100W speaker(s) One speaker – 105 Watts RMS Two speakers - 180 Watts RMS AUDIO MODE OUTPUT POWER: 14 VDC input, 100W speaker(s) One speaker –...

Page 3 - emergency equipment.

TB0346A Page 3 of 12 05/07/05 INSTALLATION Proper installation of the unit is essential for years of safe, reliable operation. Please read all instruction before installing the unit. Failure to follow these instructions can cause serious damage to the unit or vehicle and may void warranties. SAFETY ...

Page 4 - - The auxiliary input normally activates the Horn

TB0346A Page 4 of 12 05/07/05 OPTION JUMPERS FUSE T- T AUX P CUT P PHSR AUX I Cut to Disable horn INSTALLER-SELECTABLE OPTIONS Carefully cutting programming resistor jumpers or traces on the printed circuit board inside the case can select various options. The cover must be removed to access the jum...

Page 5 - CONNECT IONS AT REAR OF UNIT WITH; ELECTRICAL CONNECTIONS; - The diagram shows the

TB0346A Page 5 of 12 05/07/05 CONNECT IONS AT REAR OF UNIT WITH CP4688-10 POWER CONNECTOR (10-Pin) (2) # 18 A WG BRN (#1 6 - 2 SP KR) 2 - SP KR - C on n ect for sa me p h ase (+ t o +) S P KR → S P KR → PO S → PO S → RA D → RA D → AU X → CU T → NE G → NE G → • • • • • • • • • • #2 2 A WG WHT (S ee b...

Page 6 - Auxiliary Input Connection; - The Cutout Input turns off any

TB0346A Page 6 of 12 05/07/05 +VDC Switching examples M ust cut AUX P opti on resi stor HOR N RING SWIT CH +VDC AUX SP LIC E HOR N RING SWIT CH +VDC AUX (Add re si stor to GN D) Ad de d SPDT S witc h HOR N HOR N -VDC switching example M OM ENT ARY FOOT SWIT CH AUX ADDED RESISTOR FOR POSITIVE SWITCHI...

Page 7 - Light Control Connections; The lighting control circuits of this unit; are not fused; . Automotive fuses or circuit breakers must be connected; Failure to install proper circuit

TB0346A Page 7 of 12 05/07/05 Light Control Connections In addition to these instructions a label located on the bottom of the unit shows the light control switch connections. Fuses / Breakers The lighting control circuits of this unit are not fused . Automotive fuses or circuit breakers must be con...

Page 8 - . Automotive fuses or circuit breakers must be; Failure to install; Switch Lead Sets

TB0346A Page 8 of 12 05/07/05 Light Control Rocker Switch Connections The following diagram shows proper connection of the rocker switch leads located at the rear. Note: Negative (NEG) connection must also be made on 10-Pin connector for rocker switches to light up. WARNING: The lighting control cir...

Page 9 - OPERATION; Sound; Turns off power to the siren section.; Volume Controls

TB0346A Page 9 of 12 05/07/05 YELP STBY WAIL ON OFF RAD MAN/PHSR HORN VOLUME RAD PA OPERATION Sound Hazard - Sound level from siren speaker (>120dBA @ 10 feet) may cause hearing damage. Do not operate siren without adequate hearing protection for you and anyone in immediate vicinity. (Ref. OSHA 1...

Page 11 - SERVICE; siren

TB0346A Page 11 of 12 05/07/05 SERVICE This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker(s), controlled devices, or improper installation. The following chart s...

Page 12 - RETURN; Technical Service; Item Part

TB0346A Page 12 of 12 05/07/05 RETURN If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888) 577-6877. Many issues can be handled over the phone. We can also be reached via e-mail at [email protected] If a product must b...