Bryant H3A - Manuals

Bryant H3A – Manual in PDF format online.

Manuals:

Manual Bryant H3A

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6

Summary

Page 2 - INSTALLATION; Check Equipment and Job Site; Inspect Equipment; Install on a Solid, Level Mounting Pad; Clearance Requirements; NOTE; Operating Ambient; WARNING; PERSONAL INJURY AND ENVIRONMENTAL; CAUTION; UNIT DAMAGE HAZARD; Outdoor Unit Connected to Factory Approved Indoor

2 INSTALLATION Check Equipment and Job Site UNPACK UNITMove to final location. Remove carton taking care not to damage unit. Inspect Equipment File claim with shipping company prior to installation if shipmentis damaged or incomplete. Locate unit rating plate on unit corner panel. It contains inform...

Page 3 - Sweat Connection; Evacuate Refrigerant Tubing and Indoor Coil; Deep Vacuum Method; MINUTES; MI; Final Tubing Check; IMPORTANT

3 Sweat Connection CAUTION ! UNIT DAMAGE HAZARD Failure to follow this caution may result in equipment damage or improper operation.Service valves must be wrapped in a heat--sinking material such as a wet cloth while brazing. Use refrigeration grade tubing. Service valves are closed from factory and...

Page 4 - Make Electrical Connections; Route Ground and Power Wires; Connect Ground and Power Wires; Compressor Crankcase Heater

4 Table 2 – Accessory Usage ACCESSORY REQUIRED FOR LOW --- AMBIENT COOLING APPLICATIONS (Below 55 ° F/12.8 _ C) REQUIRED FOR LONG LINE APPLICATIONS* REQUIRED FOR SEA COAST APPLICATIONS (Within 2 miles/3.22 km) Ball Bearing Fan Motor Yes { No No Compressor Start Assist Capacitor and Relay Yes Yes No ...

Bryant Manuals