Brinkmann Series 2210 - Manuals

4 WARNING WARNING LP GAS CYLINDER (NOT SUPPLIED WITH THIS GRILL) The LP cylinder is available for purchase at the same location the grill was purchased. The LP (Liquid Propane) gas cylinder specifically designed to be used with this grill must havea 20 lb. (9.1 kg) capacity incorporating a Type 1 cy...

5 The cylinder must also be equipped with: • A shut-off valve terminating in a Type 1 gas cylinder valve outlet. • A Type 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut-off valve. • A safety relief devi...

FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can cre...

7 WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on"Leak Testing" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill must be used. • DO NOT attempt to connect it to any other fuel sup...

LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use...

LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the "OFF&...

LIGHTING THE SIDE BURNER: 1. Open lid before lighting side burner. 2. Make sure control knob is in the "OFF" position. 3. Push and turn side burner control knob to the "HIGH" position. 4. Press the electronic igniter on the main control panel and hold for 3 – 5 seconds to light burne...

ROTISSERIE COOKING: • Your grill was pre-drilled from factory to include mounting holes for a rotisserie (sold separately). Donot use a rotisserie not specifically manufactured for this grill. • Read and follow all instructions provided with the rotisserie. Save instructions for future reference. • ...

14 GRILL COOKING TIPS CLEANLINESS • Always wash hands thoroughly with soap and hot water prior to handling food and after handling rawmeat, uncooked poultry or seafood. • When using a platter to carry raw meat, uncooked poultry or seafood to the grill, make sure to wash theplatter thoroughly with so...

BURNER ASSEMBLY/MAINTENANCE • Although your burners are constructed of cast iron, they may rust as a result of the extreme heat andacids from cooking foods. Regularly inspect the burners for cracks, abnormal holes, and other signs ofcorrosion damage. If found, replace the burner. • DO NOT obstruct t...

16 TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connectionsare free of leaks. Refer to instructions for Leak Testing. • DO NOT store a spare LP gas cyl...

17 TROUBLE SHOOTING Problem: Possible Causes: 1. Check LP cylinder fuel level.2. Bad electrode spark. Check to see if the grill will match light.Electrode or collector may need adjustment. 3. Burner may not be properly seated.4. Burner may be obstructed.5. The cylinder valve may be closed.6. Regulat...

18 Your grill's serial number and model number, and the contact information for Brinkmann Customer Service, arelisted on a silver label found on the back of the grill or on the grill body side, under the side shelf. These questions and answers are for your general knowledge, and may not be applicabl...

20 2 M8 X 15mm hex head bolts 2 M8 X 15mm shoulder bolts 8 M6 X 12mm bolts 1 AA /1.5V Alkaline battery 2 Large Star Washers 6 Small Star Washers PARTS BAG CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. Your Parts Bag wi...

ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following provided tools are required to assemble this Brinkmann Pro Series 2210 Grill: • Flathead Scre...

28 Step 13 Attach the hose heat shield to theright side of the cart frame usingtwo #8 self-tapping screws. Step 14 Remove two bolts and washersfrom the side burner valve. Insertthe side burner valve assemblythrough the hole in the side burnertable base, then firmly seat thevalve nozzle into the burn...

140-2210-111/05 Owner’s Manual for Models 810-2210-1 ©2005 The Brinkmann Corporation Dallas, Texas 75244 U.S.A www.brinkmann.net The Brinkmann Corporation warrants to the original purchaser that the Brinkmann ProSeries 2210 TM is free from defects due to workmanship or materials for: Die cast parts ...