Brinkmann 4445 - Manuals

4 WARNING WARNING LP GAS CYLINDER (NOT SUPPLIED WITH THIS GRILL) The LP cylinder is available for purchase at the same location the grill was purchased. The LP (Liquid Propane) gas cylinder specifically designed to be used with this grill must havea 20 lb. (9.1 kg) capacity incorporating a Type 1 cy...

5 The cylinder must also be equipped with: • A shut-off valve terminating in a Type 1 gas cylinder valve outlet. • A Type 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut-off valve. • A safety relief devi...

FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can cre...

7 WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on"Leak Testing" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill must be used. • DO NOT attempt to connect it to any other fuel sup...

LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use...

LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the "OFF&...

LIGHTING THE ROTISSERIE BURNER: 1. Open grill hood before lighting rotisserie burner. 2. Make sure control knob is in the "OFF" position. 3. Push and turn the control knob of that burner to the "HIGH" position. Continue to push in control knob while pressingelectronic igniter for 3 –...

12 MATCH LIGHTING THE SIDE BURNER: 1. Open the lid to the side burner before lighting. 2. Make sure control knob is in the "OFF" position. 3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner. 4. Turn the side burner control knob to the "HIGH" posi...

ROTISSERIE COOKING: • This grill has pre-drilled mounting holes for a rotisserie (sold separately). Do not use a rotisserie notspecifically manufactured for this grill. • Read and follow all warnings and instructions in the owner’s manual provided with the rotisserie. Saveinstructions for future ref...

15 GRILL COOKING TIPS CLEANLINESS • Always wash hands thoroughly with soap and hot water prior to handling food and after handling rawmeat, uncooked poultry or seafood. • When using a platter to carry raw meat, uncooked poultry or seafood to the grill, make sure to wash theplatter thoroughly with so...

16 BURNER ASSEMBLY/MAINTENANCE • Although your burners are constructed of cast-iron, they may corrode as a result of the extreme heat andacids from cooking foods. Regularly inspect the burners for cracks, abnormal holes, and other signs ofcorrosion damage. If found, replace the burner. • DO NOT obst...

17 TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connectionsare free of leaks. Refer to instructions for Leak Testing. • DO NOT store a spare LP gas cyl...

18 TROUBLE SHOOTING Problem: Possible Causes: 1. Check LP cylinder fuel level.2. Bad electrode spark. Check to see if the grill will match light.Electrode or collector may need adjustment. 3. Burner may not be properly seated.4. Burner may be obstructed.5. The cylinder valve may be closed.6. Regulat...

19 Your grill's serial number and model number, and the contact information for Brinkmann Customer Service, are listedon a silver label found on the back of the grill or on the grill body side, under the side shelf. These questions and answers are for your general knowledge, and may not be applicabl...

21 ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following provided tools are required to assemble this Elite Series ™ 4445 Stainless Steel Gas Grill...

23 12 M6 X 50mm Bolts 22 M6 X 15mm Bolts 12 M4 X 10mm Bolts 4 M4 X 40mm Bolts PARTS BAG CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. Your Parts Bag will include: M6 X 50mm Bolts M4 X 40mm Bolts M4 X 10mm Bolts Star Wa...

25 NOTE: With the help of a friend, turn the cart to its upright position. Step 4 Place tank tray assembly over vent holes in bottom cart panel and secure using four M6 X 15mm bolts. Tank tray should slide in and out of cart freely. Step 5 Install door bracket using fourM6 X 50mm bolts. Make sure th...

31 Step 21 Remove two bolts and washersfrom the side burner valve. Insertthe side burner valve assemblythrough the hole in the side burnertable base, then firmly seat thevalve nozzle into the burner venturi.Hold in place while you performStep 22. Warning: Never use your grill without leak testing al...

©2006 The Brinkmann Corporation Dallas, Texas 75244 U.S.A www.brinkmann.net Owner’s Manual for Model 810-4445-1 The Brinkmann Corporation warrants to the original purchaser that the Elite Series ™ 4445 is free from defects due to workmanship or materials for: Stainless Steel & Die cast parts - L...