Page 2 - DANGER; IMPORTANT SAFETY; WARNINGS; Shut off gas to the appliance at the LP cylinder and burners.; WARNING
WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WA...
Page 3 - USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR GAS GRILL.
2 WARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and aftereach tank refill. • Never check for leaks using a match or op...
Page 4 - CYLINDER SPECIFICATIONS:; LP GAS CYLINDER; DO NOT connect to a propane cylinder exceeding this capacity.; INSTALLATION INFORMATION:
CYLINDER SPECIFICATIONS: When purchasing or exchanging a cylinder for your gas grill, it must be constructed and marked inaccordance with the specifications for LP gas cylinders of the U.S. Department of Transportation(DOT) or the National Standard of Canada, CAN/CSA-B339 as applicable with a listed...
Page 6 - FILLING THE LP GAS CYLINDER:
WARNING FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks...
Page 7 - CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER; Insure the tank valve is
6 WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on"Leak Testing" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill is designed to work with anLP gas supply cylinder. • DO NOT attemp...
Page 8 - WHEN TO PERFORM A LEAK TEST:; Any time your grill has been moved.
LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use...
Page 10 - LIGHTING INSTRUCTIONS:; Follow the instructions exactly.; LIGHTING THE MAIN BURNERS:
LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the OFF posit...
Page 12 - DO NOT leave your grill unattended while in use.
11 OPERATING THE GRILL: Never use Charcoal or Lighter Fluid inside your Gas Grill. Read and follow all warnings andinstructions contained in the preceding sections of this manual. BREAKING IN YOUR GRILL: • In manufacturing and preserving the components of your grill, oil residue may be present on th...
Page 13 - In Canada: the Canadian Electrical Code – CSA C22.1; USING OTHER FEATURES OF THE GRILL:; Read instructions on lighting your grill to light the side burner.
ROTISSERIE COOKING: • Your grill was pre-drilled from factory to include mounting holes for a Brinkmann rotisserie (soldseparately). Do not use a rotisserie not specifically manufactured for this grill. • Read and follow all instructions provided with the rotisserie. Save instructions for future ref...
Page 14 - TRANSPORTING AND STORAGE:; DO NOT extinguish grease fires using water.; BEFORE STORING YOUR GRILL:
TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connectionsare free of leaks. Refer to instructions for leak test on page 7 of this manual. • DO NOT store...
Page 15 - NOTE: Wear eye protection when performing procedure 6.; IMPORTANT: Burner tubes must reengage valve openings.; COOKING GRILLS
CLEANING AND MAINTENANCE: • For safe grilling and peak performance of your grill, perform these checks at least twice per year orafter extended periods of storage. HARDWARE • Be sure to tighten up all hardware (nuts, bolts, screws, etc.) at least twice per year. CASTINGS • Remove the cooking grills,...
Page 17 - GRILL COOKING TIPS; CLEANLINESS; HELPFUL HINTS; PROPER CARE & MAINTENANCE
16 • To protect your grill from excessive rust, the unit must be kept clean and covered at all times when not inuse. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • Wash cooking grills and heat shields with hot, soapy water, rinse well and dry. Lig...
Page 18 - ASSEMBLY INSTRUCTIONS; READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY; Flathead Screwdriver
ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following provided tools are required to assemble this Brinkmann Pro Series 2610 Grill: • Flathead Scre...
Page 20 - PARTS CARD CONTENTS
19 8 M6 X 12mm bolts 8 M6 X 20mm bolts 14 M6 X 60mm bolts 1 AA /1.5V Alkaline battery PARTS CARD CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS beforeyou begin the installation process. Your Parts Bag will include: M6 X 12mm bolts M6 X 20mm bolts M6 X 60mm bolts...
Page 22 - Note: Leave bolts hand tight until
Note: With the help of a friend, turn the cart over, try to minimizethe stress to the side panels. Step 3 Attach locking casters to the bottomof the cart. Tighten caster boltssecurely using hex nut wrenchprovided in parts pack. Note: With the help of a friend, turn the cart to its uprightposition. S...
Page 23 - Tank Tray Assembly
22 Step 5 Place tank tray assembly over ventholes in bottom cart panel andsecure using four M6 X 12mmbolts. Tank tray should slide in andout of cart freely. Step 6 Install door bracket using the four#10 X 1/2” self taping screws. Makesure door stop is set toward back ofcart. Wing Bolt Center Cut-out...
Page 26 - Warning: Never use your grill; Side burner grate
25 Step 10 Attach side burner assembly to grillbody assembly by inserting fourM6 X 20mm bolts through theholes in the side burner assemblyand into holes of grill bodyassembly. Tighten all four bolts.Install side burner grate and controlknob. Step 11 Remove the plastic cap on gassupply manifold and a...
Page 30 - ACCESSORIES
PROFESSIONAL SHISH-KABOB SKEWERS These heavy-duty, 18" shish-kabob skewers are extra-long for fabulousrestaurant style kabobs. Made of rust resistant stainlesssteel to last for years. SET OF 12812-2904-0 ACCESSORIES 29 RIB RACK Chrome-plated rack can greatly increase the cookingcapacity of your ...
Page 31 - WHERE SMOKERS ARE SOLD, OR ORDER DIRECT BY CALLING
ACCESSORIES LOOK FOR THESE AND OTHER BRINKMANN ACCESSORIES AT YOUR LOCAL RETAILER WHERE SMOKERS ARE SOLD, OR ORDER DIRECT BY CALLING 1-800-468-5252. THE ULTIMATE 5-PIECE BBQ TOOL SET You’ll be the envy of your fellow outdoor chefs withthis ultimate BBQ tool set. It’s sleek ergonomicdesign combined w...
Page 32 - WARRANTY
140-2610-18/02, 12/03 WARRANTY ©2002 The Brinkmann Corporation Dallas, Texas 75244 U.S.A www.brinkmanncorp.com The Brinkmann Corporation warrants to the original purchaser that the Brinkmann Stainless Steel Pro Series 2610 TM is free from defects due to workmanship or materials for: Stainless steel ...