Bostitch N88WW/N88RH - Manuals

Page 3 - SAFETY INSTRUCTIONS; AIR SUPPLY AND CONNECTIONS

-3- SAFETY INSTRUCTIONS EYE PROTECTION which conforms to ANSI specifications and provides protectionagainst flying particles both from the FRONT and SIDE should ALWAYS be wornby the operator and others in the work area when loading, operating or servicingthis tool. Eye protection is required to guar...

Page 4 - N88 TOOL SPECIFICATIONS; FASTENER SPECIFICATIONS:; OPERATION

-4- N88 TOOL SPECIFICATIONS All screws and nuts are metric. FASTENER SPECIFICATIONS: N88WWThis tool uses a 28° wire collated stick nail in lengths of 2” to 3-1/2” (50 - 90mm) and shank diameters of .113” to .131” (2.8 - 3.3mm)N88RHThis tool uses a 21° plastic collated full round head stick nail in l...

Page 5 - LUBRICATION; COLD WEATHER OPERATION:

AIR SUPPLY AND CONNECTIONS Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury. FITTINGS: Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected from the...

Page 6 - LOADING THE N88; Allow pusher spring to pull the pusher

EYE PROTECTION which conforms to ANSI specifications and provides protec-tion against flying particles both from the FRONT and SIDE should ALWAYS beworn by the operator and others in the work area when loading, operating or ser-vicing this tool. Eye protection is required to guard against flying fas...

Page 7 - TO ADJUST THE FASTENER; FASTENER DEPTH CONTROL ADJUSTMENT

-7- The Fastener Depth Control Adjustment feature provides control of the nail drive depth from flush with or just above thework surface to shallow or deep countersink. TO ADJUST THE FASTENER DEPTH CONTROL: DISCONNECT TOOL FROM AIR SUPPLY BEFORE ATTEMPTINGANY PARTS DISASSEMBLY AND BEFORE CHANGING TH...

Page 8 - BEFORE HANDLING OR OPERATING THIS TOOL:; CONTACT TRIP OPERATION

TOOL OPERATION OPERATION EYE PROTECTION which conforms to ANSI specifications and provides pro-tection against flying particles both from the FRONT and SIDE shouldALWAYS be worn by the operator and others in the work area when loading,operating or servicing this tool. Eye protection is required to g...

Page 9 - TOOL OPERATION CHECK:

TOOL OPERATION CHECK: CAUTION: Remove all fasteners from tool before performing tool operation check. 1. CONTACT TRIP OPERATION: A. With finger off the trigger, press the contact trip against the work surface. THE TOOL MUST NOT CYCLE. B. Hold the tool off the work surface, and pull the trigger. THE ...

Page 10 - MAINTAINING THE PNEUMATIC TOOL; ASSEMBLY PROCEDURE FOR SEALS:

-10- MAINTAINING THE PNEUMATIC TOOL When working on air tools, note the warnings in this manual and use extra care evaluating problem tools. CAUTION: Pusher spring (constant force spring). Caution must be used when working with the spring assembly. The spring is wrapped around, but not attached to, ...

Page 11 - TROUBLE SHOOTING

Trigger valve housing leaks air O-ring cut or cracked . . . . . . . . . . . . . .Replace O-ring Trigger valve stem leaks air O-ring/seals cut or cracked . . . . . . . . . .Replace trigger valve assembly Frame/nose leaks air Loose nose screws . . . . . . . . . . . . . . .Tighten and recheckO-ring or ...

Page 12 - N88 DRIVER MAINTENANCE INSTRUCTIONS

N88 DRIVER MAINTENANCE INSTRUCTIONS Worn driver causing poor quality or loss of power: - Wear on the driving tip will affect the nail drive, giving symptoms of bent and incompletely driven nails, and damaged nail heads. - The driver length may be adjusted to allow the driving tip to be redressed to ...