Blaupunkt TravelPilot 100- Manuals

First use | Installation in the vehicle 7 Select simple mode/expert mode After setting up the language and confi rming the licensing contract, 2 modes are offered for opera-tion. Note: The mode can be switched at any time (for op-eration see chapter "2.1 Simple and Advanced modes" in separate...

8 Installation in the vehicle | Switching on/off Inserting the device in the mounting cup The device features 2 recesses on the underside and one recess on the rear side for the mounting cup. Place the device onto mounting cup with the underside fi rst and push it to the back.The clamping holder of t...

Technical data 9 Technical data Dimensions (W x H x D) 99 x 99 x 16.9 mm Weight approx. 175 g Operating temperature -20 °C ... 60 °C Storage temperature -30 °C ... 70 °C Power supply Battery: Li-ion, 3.7 V/850 mAh Charger cable for cigarette lighter: Input 12 V Battery charger: Input 100 to 240 V (5...

10 Troubleshooting table Troubleshooting table Problem Cause Measure The device does not work or does not work correctly. The operating system is over-loaded. Perform a reset (Ch. "Switching on/off") Reset the factory settings (ch. "4.4.7 User Data Management" in separate navigation ...

Warranty 13 Warranty Dear Customer, Thank you for buying Blaupunkt Navigation system. This unit comes with 12 months warranty on the product from the date of purchase against defective material or workmanship. In case of a defect, Blaupunkt undertakes to get the set repaired / replaced as per compan...

14 Warranty PART B CUSTOMER’S COPY MODEL No: ___________________________________ DATE OF PURCHASE: __________________________ UNIT Sr. No.: ___________________________________ CUSTOMER NAME & ADDRESS_______________________________________________ _______________________________________________ T...

Mobile Nav igation TravelPilot 100TravelPilot 300TravelPilot Lucca 3.5 www.blaupunkt.com Navigation instructions NaviManual_iGo_India_GB.indd 1 NaviManual_iGo_India_GB.indd 1 20.08.2008 15:46:39 Uhr 20.08.2008 15:46:39 Uhr

6 1 Warnings and Safety information 1 Warnings and Safety information The navigation device does not release you from your responsibility as a driver for correct and prudent behaviour in traffi c. DANGER! Distraction from the traffi c can cause accidents Do not operate the device while driving. View t...

2 Getting started with TravelPilot 7 2 Getting started with TravelPilot TravelPilot is optimised for in-car use. You can use it easily by tapping the screen buttons and the map with your fi ngertips. Tasks Instructions Using the retractable stylus You do not need a stylus to use TravelPilot. Tap the ...

8 2 Getting started with TravelPilot Tasks Instructions Gestures (drag&drop) You do not need gestures to access the basic navigation features. You need to drag and drop the screen only in cases like: Moving the handle on a slider. Moving the map: grab the map, and move it in the desired directio...

10 2 Getting started with TravelPilot You can turn mobile devices on or off at any time. When mobile devices is switched off, TravelPilot does not calculate your GPS position and it does not update the route or the driving instructions. When you turn the device on again, TravelPilot continues naviga...

2 Getting started with TravelPilot 11 Type Example Description How to use it Switch When there are only two choices, a checkmark shows whether the feature is enabled. Tap it to turn the switch on or off. Virtual keyboard Alphabetic and alphanumeric keyboards to enter text and numbers. Each key is a ...

12 2 Getting started with TravelPilot 2.4 Using the map The map screen is the most frequently used screen of TravelPilot. It can be accessed from the Navigation menu by tapping . For further information about the map screen, see page 40. 2.4.1 Checking the details of a map location If you are intere...

2 Getting started with TravelPilot 13 Action Button(s) Description Moving the map with drag&drop No buttons You can move the map into any direction: tap and hold the map, and move your fi nger to the direction in which you want to move the map. If GPS position is available and you have moved the ...

2 Getting started with TravelPilot 15 Action Button(s) Description Fit-to-screen This button does not appear on the Map screen. It is available on the following screens: Plan on Map screen: When you have an active route, you can display it in its full length on the map. Track Information screen: A t...

16 2 Getting started with TravelPilot Icon Information Details Action , Next route event (next manoeuvre) GPS position and an active route are available, and you navigate the recommended route. This area gives you information about the type and distance of the next route event. Tap this area to open...

2 Getting started with TravelPilot 19 Button Action Saves the Cursor as a POI(available in Advanced mode only) Saves the Cursor as a Favourite location Saves the Cursor as a Road Safety Camera location (available in Advanced mode only) Marks the map with a Pin at the Cursor (available in Advanced mo...

2 Getting started with TravelPilot 21 2.5.2.4 Original position in the Cursor menu When the Cursor menu is open, a special icon ( ) shows the Cursor position the menu was opened with. You can move and zoom the map, and you can set the Cursor to a different place. The usual Cursor ( ) appears, and th...

2 Getting started with TravelPilot 23 You have the following options on the Itinerary screen: Button Description Any of the list items Opens the map with the selected manoeuvre in the middle. Changes the detail level of the Itinerary. The levels are as follows: Detailed Instructions: all intersectio...

24 2 Getting started with TravelPilot 2.5.8 Route demonstration A simulation drives you through the route, following the driving instructions (page 36). You can choose from a simulation at high speed or at normal driving speed. You can use it, for example, to see which bridge TravelPilot planned for...

2 Getting started with TravelPilot 25 Saving Road Safety Cameras To save the location of a Road Safety Camera, place the Cursor ( ) at the desired location, then tap the following buttons: , , . Camera warning The warning for Road Safety Cameras can be turned on in Warning Settings. Tap the followin...

26 2 Getting started with TravelPilot Symbol Type Description Section control These speed cameras work in pairs, and do not measure your current speed but your average speed between the two speed cameras. Both identify your car and record the exact time you pass them. They use the difference between...

3 Navigating with TravelPilot 27 3 Navigating with TravelPilot You can set up your route in TravelPilot in several ways: if you need a simple route (a route with only one destination, without any intermediate via points), you can select the destination and start navigating to it right away you can p...

28 3 Navigating with TravelPilot 3.1.2 Entering an address or part of an address If you know at least a part of the address, it is the quickest way to select the destination of the route. Using the same screen, you can fi nd an address by entering: the midpoint of a street an intersection the centre ...

3 Navigating with TravelPilot 31 The map appears with the selected point in the middle. Tap (Simple mode) or (Advanced mode) from the Cursor menu. The route is then automatically calculated, and you can start navigating. 3.1.2.4 Tips on entering addresses quickly When you are entering the name of a ...

3 Navigating with TravelPilot 33 3.1.5 Selecting the destination with a saved POI search criteria POI search criteria can be saved in the POI section of the Manage menu, but TravelPilot is already shipped with some saved criteria you can use instantly when searching for a POI. The procedure is expla...

3 Navigating with TravelPilot 35 3.3 Creating a multi-point route (appending a new destination) Multi-point routes are created from simple routes, so a route must be active fi rst. One of the ways of expanding the route is to add a new destination. The previous destination becomes the last via point ...

36 3 Navigating with TravelPilot 3.5 Viewing the whole route on the map (Fit-to-Screen) The map can be moved and scaled to show the whole line of the route. You do not need to manipulate the map manually. The Plan on Map feature does it for you. In Advanced mode you have the following options to ent...

3 Navigating with TravelPilot 37 3.9 Deleting the next via point from the route The easiest way to delete the upcoming route point (the next via point) in both Simple mode and Advanced mode is to open the Route Information screen by tapping the Turn Preview fi eld ( ) on the Map screen, and then tapp...

38 3 Navigating with TravelPilot Repeat the above steps, then tap later to stop the recording. TravelPilot labels the Track Log with a time stamp. (As an alternative, you can tap the button in the Quick menu to start, and later to stop the Track Log recording.) Simulating a Track Log on the map Tap ...

3 Navigating with TravelPilot 39 In the very likely case when the start position of the saved route is different from the current GPS position, you need to confi rm whether you want to stop navigating from the current GPS position to use the start point of the loaded route. If you choose this option,...

40 4 Reference book (Advanced mode) 4 Reference book (Advanced mode) On the following pages you will fi nd the description of the different menu screens of TravelPilot in Advanced mode. In Simple mode, these functions work the same way, but only a few of them are available. The Navigation menu: Trave...

4 Reference book (Advanced mode) 45 4.1.1.2 Status indicator strip This is a complex indicator. In one strip it indicates the following status information: Icon Description The sound output of TravelPilot is muted. The sound output of TravelPilot is enabled. TravelPilot records a Track log when GPS ...

4 Reference book (Advanced mode) 49 Button Description Opens a new screen with the address and coordinate of the Cursor, and the list of nearby POIs. Opens the full-screen Cursor menu with all the possible options. A new route is calculated with the Cursor as the destination. The previous route is d...

50 4 Reference book (Advanced mode) Button Description The Cursor is saved as the location of a Road Safety Camera (speed camera or red light camera). A new screen appears where you can set the type of the camera, the direction of the measured traffi c, and the speed limit checked (if applicable). If...

4 Reference book (Advanced mode) 53 Name Description Function Distance Remaining Shows the distance you need to travel on the route before reaching your fi nal destination. Tap this fi eld to show it on the map screen in one of the Trip Data fi elds. Time Remaining Shows the time needed to reach the fi ...

4 Reference book (Advanced mode) 55 If you tap any of the switches in the Quick menu except for the Vehicle type, the Map screen immediately returns. A switch is on if its lamp is lit. The Vehicle type button is different. It is a multi-value button. It opens a list of available choices, and the sym...

66 4 Reference book (Advanced mode) Button Description Voice Guidance Volume The slider adjusts the loudness of voice prompts. In its leftmost position, the voice guidance is suppressed; in its rightmost position, the master volume applies. Key Sounds Key sounds are audible confi rmation of either pr...

4 Reference book (Advanced mode) 69 Time and Time Zone Settings: Button Description Auto Time Correction to GPS Use this feature to synchronise the clock of your device to the very accurate time provided by the GPS receiver. Use Auto Time Zone Use this feature to synchronise the time zone of the clo...

5 Glossary 73 5 Glossary 2D/3D GPS reception The GPS receiver uses satellite signals to calculate its (your) position and need at least four signals to give a three-dimensional position, including elevation. Because the satellites are moving and because objects can block the signals, your GPS device...

74 5 Glossary Route A series of destinations to be reached one after the other. A simple route contains one start point and only one destination. Multi-point routes contain one or more via points (intermediate destinations). The last route point is the fi nal destination and the route is cut into dif...

6 End User Licence Agreement 75 6 End User Licence Agreement 1. The contracting parties 1.1. Contracting parties to present Agreement are, on the one hand: Nav N Go Kft (23 Bérc utca, H-1016 Budapest, Hungary; Hungarian reg.no.: 03-09-111944) as Licensor and the legal user (as defi ned in Section 2) ...

76 6 End User Licence Agreement 5. Owner of copyrights 5.1. The Licensor - unless contractual or legal regulations state otherwise - is the exclusive owner of all material copyrights vested in the software product. 5.2. Copyrights extend to the whole software product and its parts separately as well...

Mobile Nav igation TravelPilot 100TravelPilot 300TravelPilot Lucca 3.5 Powered by Maps MapmyIndia Maps End User License Agreement This End-User License Agreement (EULA) is a legal agreement between you (either an individual or a single entity) and CE INFO SYSTEMS PVT. LIMITED for the digital maps da...

5. Limitation of Liability. CE INFO SYSTEMS PVT LIMITED shall not be held responsible for any actual, anticipated or speculative loss of profi t or direct, indirect, incidental, special, or consequential damages, including, without limitation, loss of revenue, data, or use incurred by you or any thir...