Page 2 - AOM-58 Monochrome 5” Monitor
AOS-58 IMPORTANT:The Voyager Observation system (AOS58) has been designed to provideyears of trouble free operation. Please read this manual thoroughly. Thismanual contains instructions to ease the installation of the camera andmonitor. The Voyager Observation system is a supplement to thestandard r...
Page 3 - Documents; There; Do not open the camera case.
4 Use without Wind Deflector Screws (#8-32 UNC x 7.5) 4 Use with Wind Deflector Screws (#8-32 UNC x 9.0) AOM-58 Monochrome MonitorQty. 1 5” Monitor 1 Snap-On Sun Visor 1 Monitor Bracket 1 Power Harness with locking connector 1 Range marker 4 Thumb screws (M5 x 15) with plain washer and spring washer...
Page 4 - MAINTENANCE
2. Attach camera to bracket using 8-32 UNC screws provided. Adjustangle as indicated in Figure 2. Use rear or end of bumper asreference point. 3. Wind deflector may be installed. This deflector is designed to reducethe build-up of dust, dirt and moisture on the camera lens. (See Figure3). AOM-58 MON...
Page 5 - switched into “reverse”.
4. To increase protection of cable, place all excess wire and extensioncable in convoluted tubing. 5. Do not twist camera cable, do not cut pigtail, or cable. WIRING CAMERA AND MONITOR1. See wiring diagram for connections to ignition, ground, and backupcircuit. (See Figure 6) 2. Wiring camera: Drill...
Page 6 - CAMERA CONTROLS AND COMPONENTS; Microphone- Waterproof microphone for audio pick up; AFFIXING DISTANCE MARKERS TO THE MONITOR SCREEN
“Day/Night” switch does not achieve the mostdesirable picture.5. Brightness: Variable control of brightness. Should be adjusted ifthe “Day/Night” switch does not achieve the mostdesirable picture.6. Volume: Variable control of internal speaker and externalspeaker volume.REAR OF MONITOR: See page 12....
Page 9 - Figure 2
Approximately 80° Field of View Back of Vehicle, View at Monitor Screen Figure 2 7 80°
Page 10 - Figure 3
Figure 3 8 Without Wind Deflector Screw for use w/Wind deflector #8-32 x 3/8" #8-32 x 5/16" Screw for use Included Wind Deflector- Optional Installation 4mm x .7mm Phillips Hex Head Screw w/Washers 4mm x .7mm x 25.4mm 4mm x .7mm x 25.4mm Phillips Hex Head Screw w/Washers 4mm x .7mm Hex Nuts ...
Page 11 - Steel Plate Reinforcement (Recommended for Secure Mounting); Figure 4; Plain Washer
Steel Plate Reinforcement (Recommended for Secure Mounting) Figure 4 9 Plain Washer Spring Washer Dashboard or Overhead
Page 12 - Monitor Mounting Hole Pattern; Figure 5
Monitor Mounting Hole Pattern Figure 5 10 20° 20° 5.275 6.240 2.250 2.677 110.0° 5-0.236 Dia. Holes
Page 13 - Figure 6
Figure 6 11 EMI FERRITE CORE REAR OF MONITOR (FEMALE BULLET DISCONNECT) 18 TEW BLK (Ground) 18 TEW BLU (Reverse Trigger) 18 TEW RED (12V) TO MONITOR CAMERA "A" INPUT TO MONITOR 20 METERS WIND DEFLECTOR- OPTIONAL INSTALLATION WATERPROOF CAMERA CONNECTION GROMMET TO SEAL THROUGH VEHICLE INTERI...
Page 14 - Monitor Operating Controls and Connections
MONITOR FRONT VIEW MONITOR REAR VIEW Monitor Operating Controls and Connections 12 4 3 2 1 6 1 2 4 3 5 A B
Page 15 - Camera Features; MICROPHONE
Camera Features 13 "NORMAL" SWITCH MIRROR/ MICROPHONE
Page 16 - WIDTH OF VEHICLE
MARKER’S EXAMPLE Figure 8 14 6 FT. 3 FT. WIDTH OF VEHICLE INDICATOR 9 FT.
Page 20 - Or visit our website at
Or visit our website at www.asaelectronics.com 16 INSTALLATION NOTES: ______________________________________________________________________________________________________________________________________________________________________________________________________________________________________...
Page 22 - Revision C