Artusi ADW5002X1 - Manuals

EN - 9 2 INSTALLATION 2.1 Machine Positioning When positioning the machine, place it in an area where dishes can be easily loaded and unloaded. Do not put the machine in an area where the ambient temperature falls below 0°C. Read all warnings located on the packaging before removing the packaging an...

EN - 10 2.4 Drain Hose (Model Depending) Connect the water drain hose directly to water drain hole or to the sink outlet spigot. This connection should be minimum 50 cm and maximum 110 cm from floor that dishwasher is placed. IMPORTANT: Items will not wash properly if a drain hose longer than 4 m is...

EN - 11 2.6 Fitting The Machine Undercounter If you wish to fit your machine undercounter, there must be sufficient space to do so and the wiring-plumbing must be suitable to do so ( 1 ). If the space under the countertop is suitable for fitting your machine, remove the worktop as shown in the illus...

EN - 12 3 TECHNICAL SPECIFICATIONS 13 3.1 General Sppearance1. Worktop 2. Upper basket with racks 3. Upper spray arm 4. Lower basket 5. Lower spray arm 6. Filters 7. Rating plate 8. Control panel 9. Detergent and rinse-aid dispenser 10. Cutlery basket 11. Salt dispenser 12. Upper basket track latch ...

EN - 14 4 BEFORE USING THE APPLIANCE 4.1 Preparing Your Dishwasher For First Use • Make sure the electricity and supply water specifications match the values indicated in the installation instructions for the machine. • Remove all packaging material inside the machine. • Set the water softener level...

EN - 15 4.4 Test Strip Run water through the tap (1min.) Keep the strip in the water (1sec) Shake the strip. Wait (1min.) Set the hardness level of your machine. 1 2 3 4 5 6 NOTE: The level is set to 3 as default. If the water is well water or has a hardness level above 90 dF, we recommend that you ...

EN - 16 Add the proper detergent for the selected program to ensure the best performance. The amount of detergent needed depends on the cycle, load size, and soil level of dishes. Do not fill detergent into the detergent compartment more than required; otherwise you can see whitish streaks or bluish...

EN - 18 5 LOADING YOUR DISHWASHER For best results, follow these loading guidelines. Loading the household dishwasher up to the capacity indicated by the manufacturer will contribute to energy and water savings. Manual pre-rinsing of tableware items leads to increased water and energy consumption an...

EN - 20 Height Adjustable Rack (peg type) The foldable racks in the upper basket enable the placement of large items such as pots and pans. Each section can be folded separately. The foldable racks can be either raised up or folded down. Upper Basket Spoon Rack The spoon rack has been designed for t...

6 PROGRAMME TABLE Programme Duration (min) Description Quick 30’ 30 Suitable for lightly soiled dishes and quick wash. Delicate 40°C 74 Suitable for lightly soiled delicate dishes. Eco 50°C 143 Standard program for normally soiled daily using dishes with reduced energy and water consumptions. Super ...

EN - 23 7 THE CONTROL PANEL 9 10 You can press the On/Off button (4) to switch on the product. On/off lights will be lit as long as the machine is on. Press the program button (5) to set the required program. Press the Start/Pause button (6) to start the program. Once the selected program has starte...

EN - 24 NOTE: You can press the delay button (2) before the program starts to delay the program start time for 1 to 19 hours. NOTE : Power On indicator (10) will be on during the machine is energized. NOTE : Rinse aid refill indicator (10) will light if rinse aid is missing/insufficient. In this cas...

8.3 Drain Pump Large food residues or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on p ieces of broken glass or...

EN - 28 9 TROUBLESHOOTING FAULT POSSIBLE CAUSE TROUBLESHOOTING The programme does not start. Your Dishwasher is not plugged in. Plug your Dishwasher in. Your Dishwasher is not switched on. Switch your Dishwasher on by pressing the On/Off button. Fuse blown. Check your indoor fuses. Water inlet tap i...

EN - 30 AUTOMATIC FAULT WARNINGS AND WHAT TO DO TROUBLE CODE POSSIBLE FAULT WHAT TO DO F5 Insufficient water Make sure the water inlet tap is open and water is flowing Separate the inlet hose from the tap and clean the filter of the hose. Contact for service if the error continues. F3 Continuous wat...