Artusi ADW5002B - User Manual

Page 2 - Thank you for choosing this product.; assist you in the operation and maintenance of your appliance.

EN - 2 Thank you for choosing this product. This user manual contains important information on safety and instructions intended to assist you in the operation and maintenance of your appliance. Please take the time to read this user manual before using your appliance and keep this book for future re...

Page 3 - CONTENTS; Installation Warnings

EN - 3 CONTENTS 1 SAFETY INSTRUCTIONS .............................................................................. 4 1.1 General Safety Warnings ..............................................................................................4 1.2 Installation Warnings ..................................

Page 8 - Pull the plug to disconnect the machine from the

EN - 8 Pull the plug to disconnect the machine from the mains, never pull on the cord.

Page 9 - INSTALLATION; Machine Positioning; on flat ground otherwise it will be unstable; Water Connection; We recommend fitting a filter to your water; Water Inlet Hose; relief valve must be fitted between the

EN - 9 2 INSTALLATION 2.1 Machine Positioning When positioning the machine, place it in an area where dishes can be easily loaded and unloaded. Do not put the machine in an area where the ambient temperature falls below 0°C. Read all warnings located on the packaging before removing the packaging an...

Page 10 - cm and maximum 110 cm from floor that

EN - 10 2.4 Drain Hose (Model Depending) Connect the water drain hose directly to water drain hole or to the sink outlet spigot. This connection should be minimum 50 cm and maximum 110 cm from floor that dishwasher is placed. IMPORTANT: Items will not wash properly if a drain hose longer than 4 m is...

Page 11 - Fitting The Machine Undercounter; If you wish to fit your machine

EN - 11 2.6 Fitting The Machine Undercounter If you wish to fit your machine undercounter, there must be sufficient space to do so and the wiring-plumbing must be suitable to do so ( 1 ). If the space under the countertop is suitable for fitting your machine, remove the worktop as shown in the illus...

Page 12 - TECHNICAL SPECIFICATIONS; Technical Specifications

EN - 12 3 TECHNICAL SPECIFICATIONS 13 3.1 General Sppearance1. Worktop 2. Upper basket with racks 3. Upper spray arm 4. Lower basket 5. Lower spray arm 6. Filters 7. Rating plate 8. Control panel 9. Detergent and rinse-aid dispenser 10. Cutlery basket 11. Salt dispenser 12. Upper basket track latch ...

Page 14 - Preparing Your Dishwasher For First; SAL; Only add water to the salt compartment

EN - 14 4 BEFORE USING THE APPLIANCE 4.1 Preparing Your Dishwasher For First Use • Make sure the electricity and supply water specifications match the values indicated in the installation instructions for the machine. • Remove all packaging material inside the machine. • Set the water softener level...

Page 15 - • Open the door of the machine.

EN - 15 4.4 Test Strip Run water through the tap (1min.) Keep the strip in the water (1sec) Shake the strip. Wait (1min.) Set the hardness level of your machine. 1 2 3 4 5 6 NOTE: The level is set to 3 as default. If the water is well water or has a hardness level above 90 dF, we recommend that you ...

Page 16 - Do not fill detergent into the detergent; Filling The Detergent; place. The dispenser should be refilled just; Using Combined Detergents; To fill the rinse aid compartment, open; In order to change the rinse aid level,; Turn off the machine to save the setting.

EN - 16 Add the proper detergent for the selected program to ensure the best performance. The amount of detergent needed depends on the cycle, load size, and soil level of dishes. Do not fill detergent into the detergent compartment more than required; otherwise you can see whitish streaks or bluish...

Page 18 - LOADING YOUR DISHWASHER

EN - 18 5 LOADING YOUR DISHWASHER For best results, follow these loading guidelines. Loading the household dishwasher up to the capacity indicated by the manufacturer will contribute to energy and water savings. Manual pre-rinsing of tableware items leads to increased water and energy consumption an...

Page 20 - Upper Basket Spoon Rack

EN - 20 Height Adjustable Rack (peg type) The foldable racks in the upper basket enable the placement of large items such as pots and pans. Each section can be folded separately. The foldable racks can be either raised up or folded down. Upper Basket Spoon Rack The spoon rack has been designed for t...

Page 22 - PROGRAMME TABLE; PROGRAMME DURATION MAY CHANGE ACCORDING TO THE AMOUNT

6 PROGRAMME TABLE Programme Duration (min) Description Quick 30’ 30 Suitable for lightly soiled dishes and quick wash. Delicate 40°C 74 Suitable for lightly soiled delicate dishes. Eco 50°C 143 Standard program for normally soiled daily using dishes with reduced energy and water consumptions. Super ...

Page 23 - THE CONTROL PANEL; NOTE

EN - 23 7 THE CONTROL PANEL 9 10 You can press the On/Off button (4) to switch on the product. On/off lights will be lit as long as the machine is on. Press the program button (5) to set the required program. Press the Start/Pause button (6) to start the program. Once the selected program has starte...

Page 24 - on during the machine is energized.; : Rinse aid refill indicator; Using the Child Lock; time for 3 seconds. “CL” will flash; Changing the Program; Cancelling the Program

EN - 24 NOTE: You can press the delay button (2) before the program starts to delay the program start time for 1 to 19 hours. NOTE : Power On indicator (10) will be on during the machine is energized. NOTE : Rinse aid refill indicator (10) will light if rinse aid is missing/insufficient. In this cas...

Page 27 - from the power supply.

8.3 Drain Pump Large food residues or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on p ieces of broken glass or...

Page 28 - TROUBLESHOOTING

EN - 28 9 TROUBLESHOOTING FAULT POSSIBLE CAUSE TROUBLESHOOTING The programme does not start. Your Dishwasher is not plugged in. Plug your Dishwasher in. Your Dishwasher is not switched on. Switch your Dishwasher on by pressing the On/Off button. Fuse blown. Check your indoor fuses. Water inlet tap i...

Page 30 - AUTOMATIC FAULT WARNINGS AND WHAT TO DO; original spare parts are used.

EN - 30 AUTOMATIC FAULT WARNINGS AND WHAT TO DO TROUBLE CODE POSSIBLE FAULT WHAT TO DO F5 Insufficient water Make sure the water inlet tap is open and water is flowing Separate the inlet hose from the tap and clean the filter of the hose. Contact for service if the error continues. F3 Continuous wat...

Page 32 - XXXXXXXXXXX