AQUARIAN THDPCAP2454HD5 - Manuals

5 Carefully pack the soil using a tamper tool or vibrating plate (See illustration 4.1 and 4.2), especially on those areas where a lot of soil was added. It is also highly recommended to firm up the edge by adding a 2 cm (3/4”) layer of stone dust (or sand). The center of the circle can then be exca...

6 Take one of the two(2) rubber rings and adjust it to the top of the drain, aligning the holes carefully. Secure with strips of adhesive tape to prevent sand from penetrating inside the holes once the drain has been installed. Se-cure one end of the long black or white hose inside the drain spout. ...

8 Begin inserting the wall into the bottom wall tracks in the middle of a joiner plate. At first, the wall should be kept in place with one or two support bars (or extra persons). One person should uncoil the wall on a beam or a plank while a second person inserts it in the bottom wall tracks. Do no...

9 8 7 You can now spread approximately 10 cm (4") of com-pacting sand all around the inside base of the wall in order to protect the liner from the cutting edges of the bottom wall tracks and the stone dust (if applicable) or install a pre-fabricated cove, if available. Level finishing sand one ...

10 9 Before pulling the liner up against the wall, insert a vacuum cleaner hose down into the pump return hole to approxi-mately 15 cm (6") from the ground. Maintain the hose in place with adhesive tape. Don't forget to block the skimmer hole with adhesive tape to prevent air from leaking in. Pl...

11 Fill the pool up to the base of the wall before stopping and removing the vacuum cleaner. PUMP RETURN FITTING After you remove the vacuum cleaner, you may install the return fitting. Place the return fitting ring against the liner and adjust it so that it is perfectly aligned with the hole in the...

13 13 Note: See the safety section. As described, all components of the filtration system should be placed to prevent a child to climb on top and gain access to the pool. Using a little bit of stone dust (or sand), level a 61 cm x 76 cm (24” x 30”) patio stone before installing the motor and filter....

14 14 Insert threaded nozzles, if applicable, in order to be able to screw the valve in the skimmer. Connect the drain hose to the bottom nozzle. Con-nect the motor hose to the side nozzle. The threads on all threaded nozzles must be cov-ered with teflon tape prior to installing in order to prevent ...