Alto-Shaam Oven / Steamer CT Express - Manuals

Alto-Shaam Oven / Steamer CT Express – Manual in PDF format online.

Manuals:

Manual

Manual Alto-Shaam Oven / Steamer CT Express

Summary

Page 2 - Installation; Wire Diagrams; Warranty

i Delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Safety Procedures and Precautions . . . . . . . . . . . . 2 Installation Site Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 3V...

Page 3 - d e l i v e r y; c a u t i o n; to pREVENt pERSoNAL INJuRy,

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 1 . d e l i v e r y This alto-shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. upon receipt, check for any possible shipping damage and report it at once to the delivering carrier. see t...

Page 4 - This appliance is intended to cook, hold; n o t e

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 2 . c a u t i o n used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored. c a u t i o n used to indicate the prese...

Page 5 - s i t e i n s t a l l a t i o n; i n s t a l l a t i o n; d a n g e r; v e n t i l a t i o n r e q u i r e m e n t s; s o u n d p r e s s u r e m e a s u r e m e n t

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 3 . s i t e i n s t a l l a t i o n i n s t a l l a t i o n d a n g e r IMpRopER INStALLAtIoN, ALtERAtIoN, ADJuStMENt, SERVICE, oR MAINtENANCE CouLD RESuLt IN SEVERE INJuRy, DEAtH, oR CAuSE pRopERty DAMAGE.READ tHE INStALLAtIoN, opERAtING AND MAIN...

Page 6 - positioning on site; Air supply vents are located at; minimum clearance requirements; Additional clearance is needed for service; To avoid equipment damage, observe

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 4 . n o t e : note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. do not tilt the oven. ® s i t e i n s t a l l a t i o n i n s t a ...

Page 7 - l i f t i n g i n s t r u c t i o n s

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 5 . l i f t i n g i n s t r u c t i o n s i n s t a l l a t i o n remove banding before lifting. lift the unit from either side of the unit, n e v e r f r o m t h e f r o n t o r b a c k . adjust the forks so that they do not damage any of the com...

Page 8 - positioning requirements; Air supply vents

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 6 . s i t e i n s t a l l a t i o n i n s t a l l a t i o n EXHAUST VENT 18" (46cm) 4" (102mm) 4" (102mm) 20" (50cm) MINIMUM 20" (50cm) positioning requirements q in order to ensure proper ventilation, a minimum distance of at ...

Page 9 - a c c e s s o r i e s

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 7 . a c c e s s o r i e s combiclean® Tablets — ce-28892 sPecially FORMulated FOR cOMbitHeRM OveNs ➥ twO (2) cONtaiNeRs / bOX , 90 Packets eacH cONtaiNeR combitherm cleaning liquid — ce-24750 sPecially FORMulated FOR cOMbitHeRM OveNs ➥ twelve (12)...

Page 10 - e s

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 8 . WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD WATEr iNLETS - DriNkiNG QUALiTY ONE (1) WATEr iNLET: 3/4" G*LiNE PrESSUrE: 30 to 90 psi 2.8 to 6.2 bar WATEr DrAiN: 1-1/2" connection WitH a 2" MiniMUM air Gap instaLL...

Page 11 - iVH

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 9 . water requirements water quality minimum standards ONE (1) COLD WATER INLETS - DRINKING QUALITY ONE (1) WATER INLET: 3/4" g*LINE PRESSURE: 30 to 90 psi 2.8 to 6.2 bar WATER DRAIN: 1-1/2" CONNECTION WITH A 2" MINIMUM AIR GAP INSTALL...

Page 13 - e l e c t r i c a l c o n n e c t i o n; an electrical wiring diagram is located behind

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 11 . e l e c t r i c a l c o n n e c t i o n i n s t a l l a t i o n d a n g e r ENSuRE poWER SouRCE MAtCHES VoLtAGE IDENtIFIED oN AppLIANCE RAtING tAG. d a n g e r to avoid electrical shock, this appliance MuSt be adequately grounded in accordanc...

Page 14 - note

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 12 . e l e c t r i c a l c o n n e c t i o n i n s t a l l a t i o n d a n g e r ELECtRICAL CoNNECtIoNS MuSt bE MADE by A QuALIFIED SERVICE tECHNICIAN IN ACCoRDANCE WItH AppLICAbLE ELECtRICAL CoDES. INTERNAL GROUND STUD CUSTOMER MUST SUPPLY CORD I...

Page 15 - m o B i l e e q u i p m e n t r e s t r a i n t; Two of the casters must be the locking type.; w a r n i n g; risk of electric shock.; Appliance must be secured

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 13 . m o B i l e e q u i p m e n t r e s t r a i n t i n s t a l l a t i o n any appliance that is not furnished with a power supply cord but includes a set of casters, stand with casters, or a stacked configuration must be installed with a tether...

Page 16 - w a t e r q u a l i t y r e q u i r e m e n t; warning; use a drinking quality, cold water supply only; ALTO-SHAAM COMBITHERM WATER QUALITY MINIMUM STANDARDS; USE A DRINKING QUALITY, COLD WATER SUPPLY ONLY

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 14 . i n s t a l l a t i o n w a t e r q u a l i t y r e q u i r e m e n t warning TO PREVENT WATER PIPES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. warning WATER SUPPLY MUST BE OPEN WHEN CLEANING P...

Page 17 - w a t e r c o n n e c t i o n s; water supply & installation; one suggested

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 15 . i n s t a l l a t i o n w a t e r c o n n e c t i o n s water supply & installation water requirements one (1) cold water inlet - drinking quality one (1) treated water inlet: 3/4" g line pressure: 30 to 90 psi 2.8 to 6.2 bar REFER TO...

Page 18 - o p t i o n a l h a n d h e l d s p r a y h o s e; Valve bracket; Sprayer hanger

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 16 . i n s t a l l a t i o n o p t i o n a l h a n d h e l d s p r a y h o s e Valve bracket i n s t a l l a t i o n 1. Two pre-drilled holes with screws in place are located at the lower rear side of the unit (same side as door opening). remove s...

Page 19 - w a t e r v a l v e; diameter connection

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 17 . i n s t a l l a t i o n w a t e r v a l v e w a t e r d r a i n a g e note: the shut-oFF valve must be in the oPen Positionwhen the oven is being used. The oven must discharge through an indirect waste pipe by means of an air gap. The drain f...

Page 20 - indicator light; v e n t l e s s h o o d m o d e l; filter door latch; o p e r a t i o n; Timed Latching Mechanism: in

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 18 . i n s t a l l a t i o n indicator light if the indicator light does not illuminate, the filters may be missing or not properly aligned. check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed prope...

Page 21 - t o p e x h a u s t v e n t

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 19 . i n s t a l l a t i o n v e n t l e s s h o o d m o d e l t o p e x h a u s t v e n t 1. Charcoal Filter: The charcoal filter should be inspected for contaminant's on a regular basis. replacement must be made at a minimum of three month inter...

Page 23 - c t e x p r e s s TM c h e c k l i s t; Use this list as a final check of oven installation conformance.; C L E A R A N C E S :; p H y S I C A L C o N D I t I o N : *

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 21 . i n s t a l l a t i o n c t e x p r e s s ™ c h e c k l i s t Use this list as a final check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims. C L E A R ...

Page 25 - unit is not operating properly, check the; PRESS THE START ICON TO ACKNOWLEDGE THE ERROR.; error call out in display; e r r o r c o d e s

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 23 . continued on next page this section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel. if your alto-shaam ® unit is not operating properly, check the follow...

Page 27 - error codes; see motor control error code list

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 25 . error codes error code error call out in display description of error possible cause e34 Steam Generator Drain pump Fault Water level in steam generator does not drop during cleaning program — Scale build up inside the steam generator drain p...

Page 30 - o r i g i n a l e q u i p m e n t l i m i t e d w a r r a n t y; THIS WARRANTY DOES NOT APPLY TO:

CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 28 . o r i g i n a l e q u i p m e n t l i m i t e d w a r r a n t y Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at Alto-Shaam’s option, subject to provi...

Page 31 - t r a n s p o r t a t i o n d a m a g e a n d c l a i m s

t r a n s p o r t a t i o n d a m a g e a n d c l a i m s all alto-shaam equipment is sold F.o.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. should damage occur in shipment, it is a matter between the carrier and the consignee. in such case...