Page 2 - SAFETY HAZARD SIGNAL WORDS; DANGER; THIS SAFETY SYMBOL MEANS; PELIGRO; LEA EL INSTRUCTIVO
TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safe...
Page 3 - CAUTION
TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safe...
Page 4 - TABLE OF CONTENTS
Rhino is a registered trademark of Alamo Group Inc. SAFETY SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2Safety Hazard Signal Words . . . . . . . . . . . . ...
Page 6 - SAFETY PRECAUTIONS; SAFETY
F-3672-1-02 Safety Section 1-2 SAFETY PRECAUTIONS A careful operator operates best. Most accidents can be avoided by observing certain precautions. Read all precautions that follow before operating your tractor and loader to help prevent accidents. Equipment should be operated only by those who are ...
Page 11 - WARNING
© 2001 Alamo Group Inc. F-3672-1-02 Safety Section 1-7 Never interfere with factory-set hydraulic calibrations. Any change in calibration could cause a failure of the equipment and result in injury. Always shut the Power Unit completely down, place the transmission in park, and set the parking brake...
Page 17 - INTRODUCTION
Page 19 - SPECIFICATIONS
SPECIFICATIONS Specifications will vary with tractor, tire size, hydraulic system and bucket used. The specifications are given for a loader equipped with 72" HD material bucket operated with an average tractor hydraulic system of 20 GPM with engine operating at 2200 RPM and control valve relief...
Page 21 - ASSEMBLY
ASSEMBLY ASSEMBLY INSTRUCTIONS INSTALLING MOUNTING BRACKETSInstall all mounting brackets on the tractor according to instructions packed with mounting kit.INSTALLING LOADERInstall loader onto mounting brackets on tractor according to instructions packed with mounting kit. INSTALLING GREASE FITTINGS ...
Page 24 - OPERATION
Page 36 - MAINTENANCE
F-3672-1-02 Maintenance Section 5-4 MAINTENANCE MAINTENANCE
Page 40 - GENERAL TORQUE SPECIFICATIONS; Torque Specifications for
MAINTENANCE MAINTENANCE USE THE FOLLOWING TORQUES WHEN SPECIAL TORQUES ARE NOT GIVEN GENERAL TORQUE SPECIFICATIONS AMERICAN STANDARD CAP SCREWS METRIC CAP SCREWS SAE Grade 5 8 Metric Class 8.8 10.9 Cap Screw TORQUE TORQUE Cap Screw TORQUE TORQUE Size FT-LBS Nm FT-LBS Nm Size FT-LBS Nm FT-LBS Nm Inch...