Advantech MIC-3081 - Manuals

Page 2 - Copyright Notice; third parties which may result from its use.; Acknowledgements; trademarks are properties of their respective owners.; CE Notification; recommend the use of shielded cables.

MIC- 3081 User Manual --- Page II Copyright Notice T his document is copyrighted, 200 3. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, t...

Page 3 - Product warranty; If you think you have a defective product, follow these steps:

MIC- 3081 User Manual --- Page III Product warranty Advantech warrants to you, the original purchaser, that each of its products will be free from defects in materials and workmanship for one year from the date of purchase. This warranty does not apply to any products which have been repaired or alt...

Page 7 - General Information

MIC- 3081 User Manual --- Page 1 1 General Information

Page 9 - 0U-High CompactPCITM Enclosure with 8-slot Backplane; Power Requirement Input:

MIC- 3081 User Manual --- Page 3 backplane may be configured for +3.3V or +5V V(I/O) CompactPCI device support. A short - bar is provided on the backplane to select the desired V(I/O) voltage. The eight rear I/O are provided directly behind the backplane for IEEE1101.11 specification, 80mm depth tra...

Page 12 - Installation

Page 13 - Initial Inspection; to repair or replace the unit.

MIC- 3081 User Manual --- Page 7 2.1 Initial Inspection We have carefully inspected the MIC- 3081 mechanically and electrically before shipping. It should be free of marks and scratches and in perfect working order upon receipt. As you unpack the MIC- 3081, check it for signs of shipping damage (dam...

Page 14 - Installation Procedures; backplane of the chassis.

MIC- 3081 User Manual --- Page 8 Figure 2-2: Rear view of MIC -3081A (with advance intelligent alarm module) 2.3 Installation Procedures 2.3.1 Card Installation and Removal The CompactPCI™ connectors are firm and rigid, and require careful handling while plugging and unplugging. Improper installatio...

Page 15 - Secure the card by locking the handles into place.

MIC- 3081 User Manual --- Page 9 chassis: To install a card: 1. Hold the card vertically. Be sure that the card is oriented correctly. The components of the card should be pointing to the right - hand side. 2. Be sure that the handles of the card are not la tched. Release the handles if they are lat...

Page 18 - drive bay

MIC- 3081 User Manual --- Page 12 Figure 2-5: Attaching the mounting brackets to a 3.5" floppy disk drive Figure 2-5: Recommended device bay configuration 1x 3.5” FDD drive bay Up to 3x 3 . 5” 5.25 drive bays (w/single ATX) Redundant 560W P/S or 460 single ATX