Addonics Technologies RCHDSAES - Manuals

Step 4 Turn over the PCB and secure the hard drive to the PCB with the mounting screws that come with the kit. Step 5 Mount the board to the bottom cover. Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the...

Model: RCHDSAES *Note: The Ruby combo hard drive with the eSATA interface must be connected to a SATA controller with hot swap capability in order to add and remove drive cartridge without rebooting. Please consult your motherboard or the add-in card manufacturer to determine hot swap support on you...

For Internal Application: (Applies to both models) Step 1: Connect a SATA cable to the 7-pin SATA data connector to the SATA interface of the cradle. Step 2 : Connect a 15- pin SATA power cable from your system’s power supply to the SATA interface of the cradle. This power connection provides power ...