Addonics Technologies RCHDSAES - Manual
Addonics Technologies RCHDSAES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step 4; Turn over the PCB and secure the hard drive to the PCB with the; Step 5; Mount the board to the bottom cover.; This mode is used when the enclosure is placed inside a drive; You can only use one power connector at a time. Either use the 4-pin; Switch
- Page 3 – RCHDSAES; RCHDSAEU; Connect the eSATA cable to the eSATA port at the back of the; Power adapter
- Page 4 – eSATA cable
Addonics
T E C H N O L O G I E S
Ruby Combo Hard Drive
RCHDSAES & RCHDSAEU
User’s Guide
Version 1.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Enclosure Overview
Step 1
Separate the top from the bottom cover of the drive enclosure by
loosening the screw as shown on the photo.
Step 2
Align the SATA connector in the 2.5” hard drive with the SATA connector
on the PCB.
Step 3
Wrap the shock absorbers around the hard drive and PCB.
shock
absorbers
PCB
top cover
2.5” SATA
hard drive
bottom cover
switch
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step 4 Turn over the PCB and secure the hard drive to the PCB with the mounting screws that come with the kit. Step 5 Mount the board to the bottom cover. Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the...
Model: RCHDSAES *Note: The Ruby combo hard drive with the eSATA interface must be connected to a SATA controller with hot swap capability in order to add and remove drive cartridge without rebooting. Please consult your motherboard or the add-in card manufacturer to determine hot swap support on you...
For Internal Application: (Applies to both models) Step 1: Connect a SATA cable to the 7-pin SATA data connector to the SATA interface of the cradle. Step 2 : Connect a 15- pin SATA power cable from your system’s power supply to the SATA interface of the cradle. This power connection provides power ...
