AcuRite 502 - Manuals

7 A B C SETUP 5-in-1 Sensor Setup 1 A-B-C Switch Set to match display unit 2 Install Batteries 4 AA Batteries 3 Rain Gauge Stabilizer Remove and discard Set the A-B-C Switch Locate the A-B-C switch inside the battery compartment. Set the A-B-C switch to A, B or C. You must select the same letter cho...

8 Set the A-B-C Switch The A-B-C switch is located inside the battery compartment. It can be set to A, B or C. However, you must select the same letter choices for both the sensor and the display unit in order for the units to synchronize. Plug-in Power Adapter For the best performance, plug in the ...

10 Select Measurement Units To select between standard units (mph, ºF, etc.) or metric units (kph, ºC, etc.):1. Press the up or down arrow buttons until “SET UNITS?” is displayed on the Selectable Category part of the display unit. 2. Press the “ ” button to set the unit preference.3. Press the up o...

11 Placement for Maximum Accuracy AcuRite sensors are sensitive to surrounding environmental conditions. Proper placement of both the display unit and the sensor are critical to the accuracy and performance of this product. Display Unit Placement Place the display unit in a dry area free of dirt and...

12 5-in-1 Sensor Installation Guidelines INSTALLATION HEIGHT Mount the sensor at a minimum height of 5 feet (1.5 meters) off the ground, in an open area. Higher is better for wind measurements - the National Weather Service recommends 33 feet high! MOUNTING OPTIONS The included mounting bracket is d...

13 OPERATION Using the Professional Weather CenterLearning Mode Self-Calibrating Forecasting use a unique algorithm to analyze changes in pressure over a time period (called Learning Mode) to determine your altitude. After 14 days, the Learning Mode icon disappears from the display screen. At this p...

15 Problem Possible Solution No outdoor sensor reception no bars • Relocate the display unit and/or the 5-in-1 sensor. The units must be within 330 ft (100 m) of each other. • Make sure both units are placed at least 3 feet (.9 m) away from electronics that may interfere with the wireless communicat...

16 Problem Possible Solution Inaccurate temperature or humidity • Make sure both the display unit and sensor are placed away from heat sources or vents (see p.11). • Make sure both units are positioned away from moisture sources (see p.11). • Make sure sensor is mounted at least 5 ft off the ground....

17 Care & Maintenance Display Unit Care Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives. Keep away from dust, dirt and moisture. Clean ventilation ports regularly with a gentle puff of air. 5-in-1 Sensor Care Clean the Sensor Clean with a soft damp cloth. Do not use caust...

18 3. Press the up or down arrow buttons to calibrate the data value higher or lower from the actual reading. 4. Press the “ ” button to confirm the calibration adjustment. Note: The “CAL” icon remains illuminated next to calibrated values. Calibrate the Rain Gauge The rain gauge on the 5-in-1 senso...

20 At AcuRite, we proudly uphold our commitment to quality technology. Chaney Instrument Co. warrants that all products it manufactures to be of good material and workmanship, and to be free of defects when properly installed and operated for a period of one year from the date of purchase. We recomm...

©Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark of the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and copy-rights are the property of their respective owners. AcuRite uses patented technology. Visit www.AcuRite.com/patents for details. Printed in...