3Com 3C18320 - Manuals

3Com 3C18320 – Manual in PDF format online.

Manuals:

Manual 3Com 3C18320

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5

Summary

Page 2 - Installation; Only qualified personnel should install this device. Use an; Keying your FDDI; Figure 1; Inserting a key; Code; Used for single-attached connections, slave or workstation port.

Installation WARNING: Only qualified personnel should install this device. Use an earthed wrist-band! Keying your FDDI Connectors Keys are provided to enable you to set up M, S, A or B connector keying on the FDDI MIC Media Module. The connectors on the fiber cable will have, or can be set up to hav...

Page 3 - Figure 2; Removing a key; Connections; Re-install the MSH module into its chassis.

Figure 2 Removing a key You may find an alternative type of key used. In that event, place the keyed lug, letter upmost, into the cut-out in the case and lay the key down with the slots towards the edge connector of the module. Push gently, down and towards the front of the unit, to engage the latch...

Page 4 - Figure 3; Type A protector; Figure 4; Type B protector; Take care to keep the ends of the connectors clean. Wipe with

Installing in a LinkSwitch Hub Remove the blanking plate from the hub which is to receive the FDDI MIC Media Module. The relevant manual will tell you where to find the plate. 1 Keep the blanking plate in a safe place so that it can be replaced if the FDDI MIC Media Module is removed. 2 Holding the ...

3Com Manuals