3Com 3C18320 - Manual

3Com 3C18320

3Com 3C18320 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
Page: / 5

Table of Contents:

  • Page 2 – Installation; Only qualified personnel should install this device. Use an; Keying your FDDI; Figure 1; Inserting a key; Code; Used for single-attached connections, slave or workstation port.
  • Page 3 – Figure 2; Removing a key; Connections; Re-install the MSH module into its chassis.
  • Page 4 – Figure 3; Type A protector; Figure 4; Type B protector; Take care to keep the ends of the connectors clean. Wipe with
  • Page 5 – Operation; Optical Safety; The remote unit is powered on.; Standards
Loading the manual

FDDI MIC M

EDIA

M

ODULE

3C18320
U

SER

G

UIDE

Interworking
Information

The 3Com® FDDI MIC Media Module has been designed to the
ANSIX3T9.5 PMD standard.

The FDDI MIC Media Module can transmit (Tx) and receive (Rx) FDDI
100Mbit/sec traffic over multi-mode Fiber Optic cable.

The FDDI MIC Media Module is used to provide connectivity to FDDI fiber
medium on the following LinkBuilder® products:

■

MSH FDDI RingBuilder Module (3C18310)

■

MSH LinkSwitch Module (3C18640)

■

FMS II LinkSwitch Hub (3C16640)

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Installation; Only qualified personnel should install this device. Use an; Keying your FDDI; Figure 1; Inserting a key; Code; Used for single-attached connections, slave or workstation port.

Installation WARNING: Only qualified personnel should install this device. Use an earthed wrist-band! Keying your FDDI Connectors Keys are provided to enable you to set up M, S, A or B connector keying on the FDDI MIC Media Module. The connectors on the fiber cable will have, or can be set up to hav...

Page 3 - Figure 2; Removing a key; Connections; Re-install the MSH module into its chassis.

Figure 2 Removing a key You may find an alternative type of key used. In that event, place the keyed lug, letter upmost, into the cut-out in the case and lay the key down with the slots towards the edge connector of the module. Push gently, down and towards the front of the unit, to engage the latch...

Page 4 - Figure 3; Type A protector; Figure 4; Type B protector; Take care to keep the ends of the connectors clean. Wipe with

Installing in a LinkSwitch Hub Remove the blanking plate from the hub which is to receive the FDDI MIC Media Module. The relevant manual will tell you where to find the plate. 1 Keep the blanking plate in a safe place so that it can be replaced if the FDDI MIC Media Module is removed. 2 Holding the ...

Other 3Com Models

All 3Com Other