Boston acoustics RM9 - Manual

Page 2 - Specifications; Boston Rally

Specifications Boston Rally Boston Rally RM6 System RM9 System Maximum Music Power 200 watts 220 watts Peak Input Power 100 watts 110 watts Continuous Music Power 50 watts 55 watts Sensitivity (1 watt/.5m) 95 dB 95 dB Nominal Impedance 4 Ω 4 Ω Frequency Response 50 –20,000Hz 35 –20,000Hz Mounting Ho...

Page 3 - Table of Contents; Notice

Table of Contents Specifications 2 Table of Contents 3 Notice 3 Tools Required 4 Before You Begin 4 Planning the Installation 5 Speaker Wiring 6 Routing the Wires 6 Installing Speakers In Factory Cutouts 7 Installation Options 8 Installing Speakers In Nonstandard Locations-RM6 10 Installing Speakers...

Page 5 - Planning the Installation

5 Planning the Installation Read all instructions carefully before you attempt any installation procedures. Make sure all operations are clear to you. Make sure you have adequate time and shelter to complete the installation. Many installations require multiple days to complete. Examine the Boston R...

Page 6 - Speaker Wiring; Routing the Wires

6 Speaker Wiring For your convenience, two sets of two-conductor wire are provided to use between the speakers and the amplifier or head-unit. Other wire may be substituted if desired as long as it is at least 18 gauge. Sometimes the stock speaker wires in the vehicle may be used. Two-conductor spea...

Page 7 - Installing Speakers In Factory Cutouts; Make sure the mounting surface provides a complete air seal

7 Installing Speakers In Factory Cutouts 1. Make sure the mounting surface provides a complete air seal between the front and the back of the speaker. If the surface is uneven, or if air can leak directly from the back of the speaker to the front, seal the air leaks with silicon sealant or weather s...

Page 8 - RM6 Installation Option; holes. Rotate the speaker until the correct holes line up.

8 RM6 Installation Option Most factory speaker locations for 6-inch speakers provide either three or four screw holes for mounting the speaker. The RM6 includes both sets of holes. Rotate the speaker until the correct holes line up. 4-hole pattern 3-hole pattern

Page 9 - RM9 Installation Option; tect the rubber surround and ensure a tight air seal. The spacer is

9 RM9 Installation Option The RM9 can also be installed from underneath the rear deck to reduce the installed height of the tweeter module. A spacer is supplied to pro- tect the rubber surround and ensure a tight air seal. The spacer is installed between the speaker and the mounting surface as shown...

Page 10 - Installing Speakers In Nonstandard Locations – RM6

10 Installing Speakers In Nonstandard Locations – RM6 Notice Check the clearance of both speaker locations. Your vehicle may not be symmetrical. (There may be multiple window controls on the driver’s side, for example.) If installing in the doors, remove the interior panel. Avoid possible speaker co...

Page 13 - Installing Speakers In Nonstandard Locations – RM9

13 Installing Speakers In Nonstandard Locations – RM9 Notice Check the clearance of both speaker locations. Your vehicle may not be symmetrical. If installing in the trunk, check for clearance with the trunk lid opened and closed. If installing in the doors, remove the interior panel. Avoid possible...

Page 16 - Warranty; If Service Seems Necessary

300 Jubilee DrivePeabody, MA 01960USA508-538-5000 Boston and Boston Acoustics are registeredtrademarks, and Boston Rally and Kortec aretrademarks of Boston Acoustics, Inc. ©1996 Covered by patents issued and/or pending. 42-652-0 Warranty For one year from the date of purchase, Boston Acoustics will ...

Boston acoustics RM9 - Manual

Table of Contents:

Summary

Other Boston acoustics Models