Bosch SHXM4AY55N/28 Installation Manual

Page 3 - Safety Definitions; NOTICE; WARNING; This indicates that minor or moderate injuries may occur as a; CAUTION

3 Safety Definitions This indicates that damage to the appliance or property may occur as a result of non-compliance with this advisory. NOTICE This indicates that death or serious injuries may occur as a result of non-observance of this warning. WARNING ! Note: This alerts you to important informat...

Page 4 - dishwasher performance.; IMPORTANT; 3′′ (84 cm) off the cabinet floor otherwise the dishwasher may not

4 Important Safety Instructions: Please READ and SAVE this information To avoid possible injury or property damage, OBSERVE ALL WARNINGS AND CAUTIONS. WARNING: These instructions are intended for use by qualified installers only. The dishwasher must be installed by a qualified service technician or ...

Page 5 - Avoiding General Hazards; to tip over and result in serious injury.; Proposition 65 Warning:; product may bear the following label as required by California:; Inspect the Dishwasher; Cancer and Reprodutive Harm -

5 WARNING Avoiding General Hazards To reduce the risk of electric shock, fire, or injury to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation. Do not use the dishwasher until it is completely installed. When opening the door on an uninstalled d...

Page 6 - Tools and Materials Needed

6 Elbow connection with 3/4” female hose threads on one end and fits your water supply line (copper tubing, compression fitting, or braided hose) on the other. Hot Water Supply Line - Minimum 3/8″ O.D. copper tubing or metal braided dishwasher supply line. Only needed if house water supply line is n...

Page 8 - Materials Supplied; Installation Guide for Fully Integrated

8 Materials Supplied (Model Dependent; for fully integrated dishwashers only) Installation Guide for Fully Integrated Door Panel

Page 10 - Enclosure Requirements; To Avoid Scalding or Electrical Shock Hazard!; Make sure the water supply and electrical supply are shut off

10 Enclosure Requirements To Avoid Scalding or Electrical Shock Hazard! Make sure the water supply and electrical supply are shut off before installation or service. To Avoid Electrical Shock/Fire Hazard! Do not allow the electrical and supply lines to touch. Note: This dishwasher is designed to be ...

Page 11 - Attach 90° elbow joint to dishwasher; Power Cord clips Kit SMZEPCC1UC.

11 Attach 90° elbow joint to dishwasher oriented as shown. Do not over- tighten. • After locating the proper place for your dishwasher, create required openings in your cabinets in order to allow for water, drain and electrical lines on the appropriate side. • The holes should be cut within the 7 x ...

Page 12 - Attaching Water Inlet and Drain Hose; • Attach elbow joint to dishwasher as shown. Do not overtighten.

12 • Carefully flip the unit over. Remove the toe panel from the front of the unit and retain for attachment to the front at a later time. Loosen the leg levelers slightly. Attaching Water Inlet and Drain Hose • Attach elbow joint to dishwasher as shown. Do not overtighten. • Attach hot water line t...

Page 13 - : Route hose toward sink PRIOR TO connection. Do not turn

13 • Flip unit back upright, making sure the waterline is not pinched. • Orient the drain hose toward direction of sink. IMPORTANT : Route hose toward sink PRIOR TO connection. Do not turn after attachment. Attach drain hose elbow (Part G) to back of unit using pli- ers to install the spring clamp (...

Page 14 - Electrical Connection; Avoid Electrical Shock Hazard!; WARN; ING

14 Electrical Connection Avoid Electrical Shock Hazard! Do not work on an energized circuit. Doing so could result in serious injury or death. Only qualified electricians should perform electrical work. Do not attempt any work on the dishwasher electric supply circuit until you are certain the circu...

Page 15 - Note: Installations requiring hard wiring and terminal block

15 Dishwasher Electrical Rating Volts Hertz Amperes Watts 120 60 12 1,440 (max) Electrical Supply The customer has the responsibility of ensuring that the dishwasher electri- cal installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for...

Page 17 - • Orient the hoses and power cord so they go towards the sink and the; Positioning the Dishwasher

17 • Orient the hoses and power cord so they go towards the sink and the power outlet. 9 Positioning the Dishwasher Do not leave coils of hoses or wires behind the dishwasher. Be sure to pull the hoses all the way into the adjacent cabinet while pushing the dishwasher in. Otherwise, the hoses can fo...

Page 19 - Installation of Mounting Brackets; Avoid Tip Over Hazard!; them is difficult and will damage the mounting brackets and the

19 Grasp mounting bracket (G) with pliers and fold bracket at the perforation over onto itself as shown in 11a. • Mount brackets on the top if your countertop is wood or other material that can easily be drilled into. (see figure 11b) • Mount brackets on the sides if your countertop is stone or any ...

Page 20 - • Attach mounting brackets to the frame with included screws (D).; Top Mount

20 • Attach mounting brackets to the frame with included screws (D). Wood Countertop/ Top Mount Stone Countertop/ Side Mount 12

Page 22 - Hot Water Supply; Water Inlet Connection; water supply is shut off.

22 Hot Water Supply The hot water heater should be set to deliver approximately 120° F (49° C) water to the dishwasher. Water that is too hot can cause some detergents to lose effectiveness. Lower water temperatures will increase run times. The hot water supply pressure must be between 15 - 145 psi ...

Page 24 - Drain Connection; NOTE: Place hose clamp (C) around end of drain hose BEFORE connecting

24 Drain Connection IMPORTANT NOTES about your drain connection: • If local ordinance require an air gap, install it according to the manufacturer’s instructions. • If the dishwasher drain hose is to be connected to a disposer dishwasher drain connection, remove the plug from the disposer’s dishwash...

Page 25 - NOTE: If your dishwasher came with a fleece kit, follow the

25 min 33” (84 cm) max 43” (110 cm) min 33” (84 cm) max 43” (110 cm) The dishwasher drain hose may be connected to the drain plumbing using a high loop in one of two ways: - Connect to the under sink dishwasher drain connection (16c). - Connect to a disposer dishwasher drain connection (16d). c d C ...

Page 26 - Success! Your installation is now complete.; Attaching the Toe Panel; tions and template for installing a fully integrated door panel.; Fully Integrated Door Panel

26 • Attach the metal toe panel (Part H) with screws (Part E) so it is flush with the floor. • Plug the unit in. Success! Your installation is now complete. H Attaching the Toe Panel 18 E If your dishwasher is a fully integrated unit, please see the included instruc- tions and template for installin...

Page 27 - Customer Service

27 NSF R SH######UC/06 FD910300001 MODEL NUMBER (NUMERO DE MODELE) BOSCH Cust. Service (SERVICE CLIENTÈLE): 1-800-944-2904 SN6P5B 10103098989100011 120 V M 0,2 kW 12,0 A 1,2 kW 60 Hz LISTED (LISTÉ ) 76x6 DISHWASHER (LAVE-VAISSELLE) E103022 Certified residential dishwashers are not intended for licen...