Bosch SHXM4AY55N/01 Installation Manual

Page 3 - They will save you time and effort and help to ensure safety and; IMPORTANT; 3′′ (84 cm) off the cabinet floor otherwise the dishwasher may not; Important Safety Instructions:

3 T o avoid possible injury or property damage, OBSERVE ALL WARNINGS AND CAUTIONS . These instructions are intended for use by qualified installers only. The dishwasher must be installed by a qualified service technician or installer. • In addition to these instructions, the dishwasher shall be inst...

Page 4 - Avoiding General Hazards; Avoiding Electrical Shock/Fire Hazards; WARNING

4 Avoiding General Hazards Do not use the dishwasher until it is completely installed. When opening the door on an uninstalled dishwasher, carefully open the door while supporting the rear of the unit. Failure to follow this warning can cause the dishwasher to tip over and result in serious injury. ...

Page 5 - the appliance. Do not use extension cords.; Avoiding Plumbing/Scalding Hazards; are certain the hot water supply is shut off.; Inspect the Dishwasher; until after the entire installation has been completed.

5 The customer has the responsibility of ensuring that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded ...

Page 6 - Tools and Materials Needed; Flat Screwdriver

6 Elbow connection with 3/4” female hose threads on one end and fits your water supply line (copper tubing, compression fitting, or braided hose) on the other. Electrical Supply Cable - Minimum #14 AWG, 2 conductor, 1 ground, insulated copper conductors rated 75° C or higher. Only needed if house el...

Page 8 - Materials Supplied; Installation Guide for Fully Integrated Door Panel

8 Materials Supplied (Model Dependent; for fully integrated dishwashers only) Installation Guide for Fully Integrated Door Panel

Page 9 - hoses to access plumbing?

9 IMPORTANT! Before you begin, you must read the safety instructions. PRE-INSTALL CHECKLIST � Unpack unit. Retain packing material until successful installation is complete. � Remove all packing material from inside the dishwasher. � Inspect parts to ensure you have all the necessary materials. � Fl...

Page 12 - Do not

12 Strip outer casing of electrical wire to expose 3" (76.2 mm) of the inner wires. Then strip 1/2" (12.7 mm) casing from each individual wire.* * If the dishwasher will be plugged into an electric receptacle, contact customer service (1-800-735-4328) to order approved power cord accessory k...

Page 13 - in back foot. Step 18 will

13 Orient the drain hose toward direction of sink. IMPORTANT : Route hose toward sink PRIOR TO connection. Do not turn after attachment. Attach drain hose elbow (Part G) to back of unit using pliers to install the spring clamp (Part B). B G B G 9 Pre-level unit before positioning under counter by tu...

Page 14 - levelers to scratch or mark floor.

14 IMPORTANT : Do not allow leg levelers to scratch or mark floor. Place hands where pictured to push into place. As you slide the unit in, guide the water line and drain hose toward the sink, and electric line beneath the unit toward the junction box at the front right side. Ensure that the excess ...

Page 15 - Do not loosen or remove; of the terminal strip marked “G”.; Hand tighten only. Do not use

15 Place the assembled strain relief plate back into the junction box and re-attach the screw. Make sure the tab on the right side of the strain relief plate is outside the junction box as you slide it into place. Do Not Over-tighten orRemove Terminal Screws 14 Note: Do not loosen or remove terminal...

Page 16 - Level the dishwasher horizontally by turning feet (1) clockwise to

16 Replace junction box cover. Make sure the cover is seated behind the front lip of the strain relief plate. Attach the cover with the screw (Part E) from the installation kit. Warning ............................ .................................................................................... ...

Page 17 - onto itself as shown in 19a.

17 Grasp mounting bracket (H) with pliers and fold bracket at the perforation over onto itself as shown in 19a. • Mount brackets on the top if your countertop is wood or other material that can easily be drilled into . (see figure 19b) • Mount brackets on the sides if your countertop is stone or any...

Page 19 - Drain Connection

19 The dishwasher drain hose may be connected to the drain plumbing using an air gap in one of two ways: - Connect to the under sink dishwasher drain connection (25a). - Connect to a disposer dishwasher drain connection (25b). NOTE: Place hose clamp (C) around end of drain hose BEFORE connecting to ...

Page 22 - Customer Service

22 Your dishwasher requires no special care other than that described in the Care and Maintenance section of the Use and Care Manual. If you are having a problem with your dishwasher, before calling for service please refer to the Troubleshooting section in the Use and Care Manual. If service is nec...