Bosch SHVM63W53N/01 - Installation Manual

Table of Contents:

• Page 2 – IMPORTANT; Inspect the Dishwasher; until after the entire installation has been completed.; Important Safety Instructions:
• Page 3 – Avoiding General Hazards; dishwasher to tip over and result in serious injury.; Avoiding Electrical Shock/Fire Hazards; you are certain the circuit is de-energized.; WARNING
• Page 4 – the appliance. Do not use extension cords.; Avoiding Plumbing/Scalding Hazards; are certain the hot water supply is shut off.
• Page 5 – Tools and Materials Needed; sized to fit your water supply line (copper tubing/
• Page 6 – Materials supplied; Junction Box
• Page 7 – Slotted Toe Panel
• Page 8 – Enclosure Requirements; Avoid Scalding or Electrical Shock Hazard!; Note: This dishwasher is designed to be enclosed on the top, back and; Select a location
• Page 9 – After locating the proper place; for your dishwasher, create required; If the opening is made through wood; method to protect wiring from damage.
• Page 10 – Pull the drain hose out; of the packaging base as shown.; Set toe panel aside; to dishwasher oriented as shown.; Attach hot water line
• Page 11 – Electrical Preparation; Make sure electrical work is properly installed. Only qualified; Electrical Supply
• Page 12 – to installation area.; Remove screws and cover; of the hardwiring/power cord as; Dishwasher Electrical Rating; Grounding Instructions; the NATIONAL ELECTRICAL CODE in the United States or the CANA-
• Page 13 – strain relief
• Page 14 – CLICK; Mount the dishwasher electrical supply junction box; receptacle; in an accessible cabinet adjacent to the dishwasher (do not; Check all electrical connections; to ensure they are secure and then reattach; Place adhesive backed cord clip; (provided in the installation kit) 5 inches from; Plug the end of the supply cord; into the back of the dishwasher as shown
• Page 15 – Installation of Mounting Brackets; NOTICE; removing them is difficult and will damage the mounting brackets; as shown in 12c such that the bracket will not
• Page 16 – with pliers at perforation and bend until; Side Mount is used for counter tops made of marble, granite, or other; side slots in frame as shown. Using pliers,; Do not attach to
• Page 17 – If your sink is to the right side; of where you are installing the dishwasher,; To do so, unhook the strap; that the hoses are running through on the; If your sink is to the left side; , leave the hoses as they came and skip to; Positioning the Dishwasher
• Page 18 – Reposition the hoses; such that they run through the strap on the other; Be sure to snap the strap back in place to secure the hoses as shown.; , use flo r protection and caution when sliding
• Page 21 – Drive the mounting screws; (E) through the holes in the mounting brackets; Securing the Dishwasher
• Page 22 – Avoid Scald Hazard; Turn on the water supply and check for leaks after connections are; Water Inlet Connections
• Page 23 – Drain Connections
• Page 24 – You may use the piece you removed in Step 7; to attach to the inside of; The dishwasher drain hose; must be installed with a portion of it at least
• Page 25 – NOTE: Place hose clamp around end of drain hose BEFORE connecting
• Page 26 – Use the clamp provided; Attaching the Toe Panel; Position the slotted toe panel (
• Page 27 – Customer Service