Bosch LR40 - User Manual - manualsarea.com

Page 2 - GlobalTestSupply; Find Quality Products Online at:

-2- MENU LR40 (1) (2) (3) (4) (5) (6) (7) (8) (a) (b) (c) (d) (e) (f) (g) (h) (i) (j) (10) (10) (10) (10) (10) (10) (9) (5) (14) (13) (12) (11) (9) (15) (16) (17) (18) (19) (20) www. GlobalTestSupply .com Find Quality Products Online at: [email protected]

Page 5 - Safety Symbols; LR40 General Safety Rules

-5- Safety Symbols The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to ...

Page 6 - FCC Caution

-6- The manufacturer is not respon-sible for radio interference caused by unauthorized modiﬁcations to this equipment. Such modiﬁcations could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:...

Page 7 - Features

-7- The numbering of the product features shown refers to the illustration of the tool on the graphic page. (1) Laser beam reception area (2) “Laser beam over center line” direction indicator (3) LED center line (4) “Laser beam below center line” direction indicator (5) Display (front and back) (6) ...

Page 9 - Intended Use; Inserting/Changing the Batteries; Assembly

-9- The laser receiver is intended to quickly find rotating laser beams of the wavelength specified in the technical data. The laser receiver is also intended for controlling the GRL4000-80 via Bluetooth ® . The laser receiver is suitable for indoor and outdoor use. Intended Use Inserting/Changing t...

Page 10 - Starting operation; Operation

-10- Starting operation X Protect the laser receiver against mois- ture and direct sunlight. X Do not subject the laser receiver to ex- treme temperatures or variations in tem-perature. As an example, do not leave it in vehicles for longer periods. In case of large variations in temperature, allow t...

Page 11 - Settings

-11- Laser receiver too high: If the laser beam hits the lower half of the reception area (1) , then the “laser beam below center line” direc-tion indicator (f) appears in the display. If the LEDs are switched on, the red “laser beam below center line” LED direction indicator (4) lights up. If the a...

Page 12 - Functions

-12- Settings menu To call up the settings menu: Press the X-axis button (16) and the Y-axis button (15) on the laser receiver at the same time. To change the setting within a submenu: Press the X-axis button (16) or the Y-axis but- ton (15) to switch between the settings. The last selected setting ...

Page 13 - Practical Advice; Rectifying errors

-13- Inclination determination with center line mode (see ﬁgure D) Using center line mode, the inclination of a surface can be measured up to max. 8.5%. To do this, set up the rotary laser at the base of the inclination in a horizontal position on a tri-pod. The X- or Y-axis of the rotary laser must...

Page 14 - Maintenance and Service

-14- Store and transport the tool only in the supplied protective case. Check the tool each time before using. Keep the tool clean and dry at all times to ensure proper and safe operation. Do not immerse the tool into water or other fluids. Wipe off debris using a moist and soft cloth. Do not use an...

Bosch LR40 - User Manual

Table of Contents:

Summary

Other Bosch Models