Bosch DVA-08K - Manual

Bosch DVA-08K

Bosch DVA-08K – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
Page: / 68

Table of Contents:

  • Page 3 – Table of Contents
  • Page 5 – Warnings and Certifications; Warning; Precautions and Instructions; Certification; FCC Class B Radio Frequency Interference Statement
  • Page 6 – CB
  • Page 7 – Introduction; This manual covers the DVA-08K series of RAID subsystems.; Product Overview; ference between the two models is the number of SATA-II drive bays.; SCSI Host Ports; These volumes then appear as SCSI targets over the host links.
  • Page 8 – Active Components
  • Page 9 – Enclosure Chassis; Chassis Overview; separately purchased slide rails.; Physical Dimensions; ual are shown in
  • Page 10 – ration and monitoring utility.; Hard Drive Numbering; the top to the bottom.; Rear Panel Overview; The subsystem rear view is shown in
  • Page 11 – the upper left corner of the controller module.; Backplane Board
  • Page 12 – Subsystem Components; LCD Panel; The LCD panel shown in
  • Page 13 – Drive Trays; The RAID Controller Module; Controller Module Interfaces
  • Page 14 – DIMM Module; Battery Backup Unit; Section 3 Hardware Installation
  • Page 15 – Power Supply Units; has failed and needs to be replaced.; Cooling Fan Modules; ble cooling modules shown in
  • Page 16 – Advanced Fault-Preventative Operation; increase the airflow:
  • Page 17 – Subsystem Monitoring; C Bus
  • Page 18 – Hot-Swappable Components; Hot-Swap Capabilities; The following components are all hot-swappable:; Normalized Airflow
  • Page 19 – Hardware Installation; Installation Prerequisites; Section 1 Warnings and Certifications
  • Page 20 – Safety Precautions
  • Page 21 – Dispose used BBUs at authorized battery disposal sites only.
  • Page 22 – General Installation Procedure; Section 3.6 Drive Tray Installation; Unpacking the Subsystem; Step; Section 3.4 Unpacking the Subsystem
  • Page 23 – Rackmounting; Considerations for Installation Site and Chassis
  • Page 24 – Drive Tray Installation; entation. If the groove is in a vertical position, as shown in; Open the front flap on the drive tray. (See; slide it in. This should be done smoothly and gently.
  • Page 25 – ognize the drives and scan them in automatically.
  • Page 26 – Subsystem Monitoring Overview; using the existing Ethernet ports.
  • Page 27 – Status-indicating LEDs; Brief Overview of the LEDs
  • Page 28 – Controller Module LEDs; LED Name
  • Page 29 – Ethernet Port LEDs
  • Page 32 – Audible Alarm; The controller self-monitoring thresholds in
  • Page 33 – Failed Devices; C Monitoring
  • Page 34 – Subsystem Connection and Operation; Basic Configuration Rules; help to bring out the most of IOPs performance.
  • Page 35 – SCSI Connection Overview; configuration principles applies to the subsystem.; SCSI Cables; subsystem to a host adapter.
  • Page 36 – SCSI Termination; erratic SCSI bus behavior may occur.
  • Page 37 – Host Connection Topology; Default Channel Settings
  • Page 38 – Power On; Power On Checklist
  • Page 39 – Power On Status Check
  • Page 40 – This screen appears when the PSUs are turned
  • Page 41 – Power Off Procedure
  • Page 42 – Subsystem Maintenance; Overview; General Notes on Component Replacement
  • Page 43 – Replacing Controller Module Components
  • Page 44 – Replacing the Controller Module
  • Page 45 – Replacing or Upgrading Memory Modules; Memory Module Installation Overview
  • Page 46 – Gently retrieve the DIMM module out of the DIMM socket. (See; screws on the sides.
  • Page 47 – Replacing a Faulty BBU; Notes on PSU Module Maintenance
  • Page 48 – lodged, gently pull the PSU module out of the subsystem.; from the chassis at the same time.
  • Page 49 – the PSU module and turn the PSU module power switch on.
  • Page 50 – Replacing a Failed Cooling Fan Module; Notes on Cooling Fan Module Maintenance; Configuration Client utility.; Replacing a Cooling Fan Module; gently pulling on the silver handle at the bottom. (See; fails, the system is at risk of sustaining irreparable damage.
  • Page 51 – Drive Tray Maintenance; Notes on Hard Drive Maintenance; Replacing a Failed Hard Drive
  • Page 53 – Place the SATA hard drive into the drive tray (as shown in
  • Page 54 – Appendix: Technical Specifications; Environmental Specifications
  • Page 55 – Safety Requirements
  • Page 56 – Controller Specifications; Configuration; Specifications
  • Page 57 – Drive Tray Specifications
  • Page 58 – Cooling Module Specifications
  • Page 59 – Fault Tolerance Management
  • Page 60 – Appendix: Spare Parts and Accessories; Spare Parts; Spare Parts Overview; Model Name
  • Page 61 – Accessories and Optional Items; * One included in the shipping package
  • Page 62 – SCSI Port: VHDCI Connector Pinouts; Pin
  • Page 63 – COM1 Cable: DB9 and Audio Jack Pinouts
  • Page 64 – Null Modem; Main Power; Swap Pin 2 and Pin 3
  • Page 65 – Index
Loading the manual

RAID Subsystem DVA-08K

DVA-08K SCSI Premium Series

en

Installation Manual

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Table of Contents

RAID Subsystem DVA-08K | Installation Manual Table of Contents | en 3 Bosch Security Systems F.01U.027.797 | V2 | 2008.08 Table of Contents 1 Warnings and Certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 1.1 Warning ...

Page 5 - Warnings and Certifications; Warning; Precautions and Instructions; Certification; FCC Class B Radio Frequency Interference Statement

RAID Subsystem DVA-08K | Installation Manual Warnings and Certifications | en 5 Bosch Security Systems F.01U.027.797 | V2 | 2008.08 1 Warnings and Certifications 1.1 Warning A shielded power cord is required in order to meet FCC emission limits and also to prevent interference to nearby radio and te...

Page 6 - CB

6 en | Warnings and Certifications RAID Subsystem DVA-08K | Installation Manual F.01U.027.797 | V2 | 2008.08 Bosch Security Systems turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receivi...

Other Bosch Models