Bosch RD ESELECT - Manuals

Bosch RD ESELECT – User Manual in PDF format online.

Manuals:

User Manual

User Manual Bosch RD ESELECT

Summary

Page 3 - Table of contents

LECTUS select E Table of contents | en 3 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Table of contents 1 Safety 4 1.1 FCC Class B 5 2 Short information 6 2.1 Introduction 6 2.2 Parts included 7 3 System overview 8 3.1 Mounting options and dimensions 8 3.2 Supported protocol 9 3.3...

Page 4 - Safety; Read, observe and keep the instructions; Take all warnings into account; Power sources

4 en | Safety LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 1 Safety – Read, observe and keep the instructions - the entire safety and operating instructions must be read and correctly followed before the readers are operated. – Take all warnings into account - foll...

Page 5 - FCC Class B

LECTUS select E Safety | en 5 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Danger! - The device must be operated in a fully assembled state only.- Before connecting the device to the power supply, make sure that the connectedoperating voltage does not exceed the permitted values a...

Page 6 - Short information; Introduction

6 en | Short information LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 2 Short information 2.1 Introduction This installation manual is aimed at authorized service providers.The installation manual contains instructions on the installation and configuration of thepr...

Page 7 - Parts included; Quantity

LECTUS select E Short information | en 7 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 2.2 Parts included x4 x2 x1 Quantity Component 1 Reader module 1 Wall bracket 4 Screws 1 Quick installation guide 2 Safety and security information

Page 8 - System overview; Mounting options and dimensions; Flush-mount installation

8 en | System overview LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 3 System overview The LECTUS select E reader reads data from contactless RFID credentials and sends thedata to a higher-level control center. This is where the evaluation takes place as to whethera...

Page 9 - Surface-mount installation; Supported protocol

LECTUS select E System overview | en 9 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Surface-mount installation Wallmount box for surface mounting (optionally available) mm 13.3 Figure 3.3: Dimensions of the reader with fixed wall bracket and mounting box Available accessories: ARA...

Page 10 - Reading distances; Type of transponder media; Key fob; Influencing (reducing) the reading distance

10 en | System overview LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. – MIFARE DESFire EV1 2k / 4k / 8k – MIFARE DESFire EV2 and EV3 – ISO 14443A transponder (CSN) 3.5 Reading distances The normal reading distance depends on the respective reading system, the instal...

Page 11 - Installation; Considerations on installation location; When choosing the installation location, please note:; Mechanical structure of the flush-mount installation

LECTUS select E Installation | en 11 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 4 Installation 4.1 Considerations on installation location When choosing the installation location, please note: The readers can interfere with each other or be negatively influenced by other systems...

Page 12 - Installing data and supply lines; Connection terminal

12 en | Installation LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 4.4 Installing data and supply lines When supplying the reader with power, especially over longer distances, ensure that thecable cross-section is adequate. Since the power consumption of the individ...

Page 13 - Wire type; Assembling the reader; Mounting the reader support

LECTUS select E Installation | en 13 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Wire type Wire Gauge Diameter Stranded wire AWG 28-16 Cable stripping length 6 to 7 mm Solid wire NOTE: No additional tool is required to connect the wires to the reader. Push the correspondent orang...

Page 14 - Configuring the reader DIP switches; DIP

14 en | Installation LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. Figure 4.4: Mounting the reader support in surface-mount installation 4.6.2 Configuring the reader DIP switches Depending on the firmware function, the DIP switches of the reader module must be setac...

Page 15 - Connecting and mounting the reader module

LECTUS select E Installation | en 15 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 1 ON OFF ON OFF ON OFF ON OFF 2 OFF ON ON OFF OFF ON ON OFF 3 OFF OFF OFF ON ON ON ON OFF 4 BUS terminator resistor (default: OFF) Table 4.1: OSDP protocol NOTE: DIP switch 4 is reserved for the BUS ...

Page 17 - Unmounting the reader module

LECTUS select E Installation | en 17 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 2 3 4 Figure 4.9: Connecting and mounting the reader the reader module in surface-mount installation 4.7 Unmounting the reader module 1. Remove the screw at the bottom of the reader module. Use a cyl...

Page 19 - Care instructions

LECTUS select E Care instructions | en 19 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 5 Care instructions – Do not operate the reader with sharp objects, such as rings, fingernails and keys. – For cleaning, do not use any corrosive or plastic-corrosive liquids such as gasoline,tu...

Page 20 - Disposal; Old electrical and electronic equipment

20 en | Disposal LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 6 Disposal Old electrical and electronic equipment This product and/or battery must be disposed of separately from household waste.Dispose such equipment according to local laws and regulations, to allow...

Page 21 - Technical specifications; Mechanical

LECTUS select E Technical specifications | en 21 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 7 Technical specifications Mechanical Dimensions (H x W x D) (mm) 81 mm x 81 mm x 24 mm Dimensions (H x W x D) (in) 3.2 in x 3.2 in x 0.9 in Color Black; Silver | White Material PVC Mount...

Page 22 - Connectivity; System integration

22 en | Technical specifications LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. Connectivity Reader interfaces RS485 System integration Protocols / standards OSDP v2 * It is not set by default. Requires specific configuration with OSDP protocol. Ask for moreinformati...

Page 23 - More information

LECTUS select E More information | en 23 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 8 More information Refer to the latest technical documentation for this product available for download in theBosch online catalog. Manufacturing dates For product manufacturing dates, go to www.b...

Page 28 - Building solutions for a better life

Bosch Security Systems B.V. Torenallee 495617 BA EindhovenNetherlands www.boschsecurity.com © Bosch Security Systems B.V., 2024 202410171746 Building solutions for a better life

Bosch Manuals

Bosch BCC111 User Manual
Bosch Air 500 Installation Manual
Bosch Air 500 Manual
Bosch SHE43C75N User Manual
Bosch WGB24600UC User Manual
Bosch WGB246AXUC User Manual
Bosch WGB246AXUC Manual
Bosch WMZPW20W User Manual
Bosch WMZPW2XW User Manual
Bosch WQB245AXUC User Manual
Bosch WQB245AXUC Manual
Bosch WQB245B0UC User Manual
Bosch WQB245B0UC Manual
Bosch WTZ27500UC User Manual
Bosch WTZ2750XUC User Manual
Bosch WTZ27510UC User Manual
Bosch WTZ2751XUC User Manual
Bosch WTZPA20UC User Manual
Bosch WTZPA20UC Manual
Bosch WTZPA30US User Manual