Page 3 - Table of contents
LECTUS select E Table of contents | en 3 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Table of contents 1 Safety 4 1.1 FCC Class B 5 2 Short information 6 2.1 Introduction 6 2.2 Parts included 7 3 System overview 8 3.1 Mounting options and dimensions 8 3.2 Supported protocol 9 3.3...
Page 4 - Safety; Read, observe and keep the instructions; Take all warnings into account; Power sources
4 en | Safety LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 1 Safety – Read, observe and keep the instructions - the entire safety and operating instructions must be read and correctly followed before the readers are operated. – Take all warnings into account - foll...
Page 5 - FCC Class B
LECTUS select E Safety | en 5 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Danger! - The device must be operated in a fully assembled state only.- Before connecting the device to the power supply, make sure that the connectedoperating voltage does not exceed the permitted values a...
Page 6 - Short information; Introduction
6 en | Short information LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 2 Short information 2.1 Introduction This installation manual is aimed at authorized service providers.The installation manual contains instructions on the installation and configuration of thepr...
Page 7 - Parts included; Quantity
LECTUS select E Short information | en 7 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 2.2 Parts included x4 x2 x1 Quantity Component 1 Reader module 1 Wall bracket 4 Screws 1 Quick installation guide 2 Safety and security information
Page 8 - System overview; Mounting options and dimensions; Flush-mount installation
8 en | System overview LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 3 System overview The LECTUS select E reader reads data from contactless RFID credentials and sends thedata to a higher-level control center. This is where the evaluation takes place as to whethera...
Page 9 - Surface-mount installation; Supported protocol
LECTUS select E System overview | en 9 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Surface-mount installation Wallmount box for surface mounting (optionally available) mm 13.3 Figure 3.3: Dimensions of the reader with fixed wall bracket and mounting box Available accessories: ARA...
Page 10 - Reading distances; Type of transponder media; Key fob; Influencing (reducing) the reading distance
10 en | System overview LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. – MIFARE DESFire EV1 2k / 4k / 8k – MIFARE DESFire EV2 and EV3 – ISO 14443A transponder (CSN) 3.5 Reading distances The normal reading distance depends on the respective reading system, the instal...
Page 11 - Installation; Considerations on installation location; When choosing the installation location, please note:; Mechanical structure of the flush-mount installation
LECTUS select E Installation | en 11 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 4 Installation 4.1 Considerations on installation location When choosing the installation location, please note: The readers can interfere with each other or be negatively influenced by other systems...
Page 12 - Installing data and supply lines; Connection terminal
12 en | Installation LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 4.4 Installing data and supply lines When supplying the reader with power, especially over longer distances, ensure that thecable cross-section is adequate. Since the power consumption of the individ...
Page 13 - Wire type; Assembling the reader; Mounting the reader support
LECTUS select E Installation | en 13 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | Wire type Wire Gauge Diameter Stranded wire AWG 28-16 Cable stripping length 6 to 7 mm Solid wire NOTE: No additional tool is required to connect the wires to the reader. Push the correspondent orang...
Page 14 - Configuring the reader DIP switches; DIP
14 en | Installation LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. Figure 4.4: Mounting the reader support in surface-mount installation 4.6.2 Configuring the reader DIP switches Depending on the firmware function, the DIP switches of the reader module must be setac...
Page 15 - Connecting and mounting the reader module
LECTUS select E Installation | en 15 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 1 ON OFF ON OFF ON OFF ON OFF 2 OFF ON ON OFF OFF ON ON OFF 3 OFF OFF OFF ON ON ON ON OFF 4 BUS terminator resistor (default: OFF) Table 4.1: OSDP protocol NOTE: DIP switch 4 is reserved for the BUS ...
Page 17 - Unmounting the reader module
LECTUS select E Installation | en 17 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 2 3 4 Figure 4.9: Connecting and mounting the reader the reader module in surface-mount installation 4.7 Unmounting the reader module 1. Remove the screw at the bottom of the reader module. Use a cyl...
Page 19 - Care instructions
LECTUS select E Care instructions | en 19 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 5 Care instructions – Do not operate the reader with sharp objects, such as rings, fingernails and keys. – For cleaning, do not use any corrosive or plastic-corrosive liquids such as gasoline,tu...
Page 20 - Disposal; Old electrical and electronic equipment
20 en | Disposal LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. 6 Disposal Old electrical and electronic equipment This product and/or battery must be disposed of separately from household waste.Dispose such equipment according to local laws and regulations, to allow...
Page 21 - Technical specifications; Mechanical
LECTUS select E Technical specifications | en 21 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 7 Technical specifications Mechanical Dimensions (H x W x D) (mm) 81 mm x 81 mm x 24 mm Dimensions (H x W x D) (in) 3.2 in x 3.2 in x 0.9 in Color Black; Silver | White Material PVC Mount...
Page 22 - Connectivity; System integration
22 en | Technical specifications LECTUS select E 2024-10 | V01 | Installation manual Bosch Security Systems B.V. Connectivity Reader interfaces RS485 System integration Protocols / standards OSDP v2 * It is not set by default. Requires specific configuration with OSDP protocol. Ask for moreinformati...
Page 23 - More information
LECTUS select E More information | en 23 Bosch Security Systems B.V. Installation manual 2024-10 | V01 | 8 More information Refer to the latest technical documentation for this product available for download in theBosch online catalog. Manufacturing dates For product manufacturing dates, go to www.b...
Page 28 - Building solutions for a better life
Bosch Security Systems B.V. Torenallee 495617 BA EindhovenNetherlands www.boschsecurity.com © Bosch Security Systems B.V., 2024 202410171746 Building solutions for a better life
