Page 3 - Table of contents
Table of contents 1 Safety 4 1.1 About this Manual 4 1.2 Conventions in this Manual 4 1.3 Legal Information 4 1.4 Important Safety Instructions 4 2 Description 6 2.1 Unpacking 6 3 Installing a Recessed Mount 7 3.1 Parts List 7 3.2 Installing the Recessed Mount 8 4 Installing a Pipe Mount 10 4.1 Part...
Page 4 - Safety; About this Manual
Safety About this Manual This manual has been compiled with great care and the information it contains has beenthoroughly verified. The text was complete and correct at the time of printing. Because of theongoing development of products, the content of the manual may change without notice.Bosch Secu...
Page 6 - Description; Unpacking
Description This manual provides instructions for mounting a AUTODOME 5000 Series PTZ Dome to theVEZ-A5-IC In-ceiling (Recessed) Mount. This mount allows you to recess the AUTODOME 5000into an indoor drop-ceiling.This manual provides instructions for mounting a AUTODOME 5000 PTZ Dome to the VEZ-A5-P...
Page 7 - Installing a Recessed Mount; Parts List; Quantity
Installing a Recessed Mount Use this chapter to install the indoor dome camera into an indoor ceiling space. Parts List Quantity Item 1 Ceiling Bracket 1 Rubber Gasket 1 Housing Frame 1 Trim Ring 3 M4x10 Phillips Screws 1 Guide Pattern 1 Installation Manual 3 3.1 AUTODOME 5000 PTZ Camera Installing ...
Page 8 - Installing the Recessed Mount
Installing the Recessed Mount The illustration below shows the required parts for the recessed mount. Refer to the stepsthat follow for instructions. 1 23 4 5 6 1 Ceiling Bracket 4 Housing Frame 2 M4x10 Screws (3 pieces) 5 Dome Camera 3 Rubber Gasket 6 Trim Ring 3.2 8 en | Installing a Recessed Moun...
Page 10 - Installing a Pipe Mount
Installing a Pipe Mount Use this chapter to install and indoor or outdoor dome camera to a pipe. Parts List Quantity Item 1 Pipe Mount Base with Safety Tether 1 300 mm (11.81 in.) Pipe Extension 1 200 mm (7.87 in.) Pipe Extension 1 M38 to M38 Connection Ring 1 M38 to M33 Connection Ring 1 3/4 x 260 ...
Page 11 - Installing the Pipe Mount
Installing the Pipe Mount The illustration below shows the required parts for the pipe mount. Refer to the steps thatfollow for instructions. 1 2 3 4 6 5 9 8 7 1 Pipe Mount Base 6 M38 to M33 Pipe Connector 2 M10x25L Phillips Screws (4 pieces) 7 Safety Tether 3 Pipe Extension, 300 mm (11.81 in.) 8 Ad...
Page 12 - Pipe Mount Installation Instructions
Pipe Mount Installation Instructions ! Caution!Strength of Mounting SurfaceThe fasteners and mounting surface must be capable of supporting a maximum load of 12 kg (26.4 pounds). 1. Locate a secure position to secure the Pipe Mount Base (1). Ensure there is an adequateopening in the ceiling or mount...
Page 14 - Installing a Wall Mount
Installing a Wall Mount Use this chapter to install and indoor or outdoor dome camera to a wall. Parts List Quantity Item 1 Wall Mount with Safety Tether 1 3/4 x 260 in. Roll Teflon Tape 1 5g Container Silicon Grease 4 M10x25L Phillips Screws 1 Rubber Gasket 1 Installation Manual 5 5.1 14 en | Insta...
Page 15 - Installing the Wall Mount
Installing the Wall Mount The illustration below shows the required parts for the wall mount. Refer to the steps thatfollow for instructions. 1 Wall Mount Base 4 Safety Tether 2 Washers (4 pieces) 5 Adaptor 3 M10x25L Phillips Screws (4 pieces) 6 Dome Camera 5.2 AUTODOME 5000 PTZ Camera Installing a ...
Page 16 - Wall Mount Installation Instructions
Wall Mount Installation Instructions ! Caution!Strength of Mounting SurfaceThe fasteners and mounting surface must be capable of supporting a maximum load of 12 kg (26.4 pounds). 1. Locate a secure position to secure the Wall Mount Base (1). Ensure there is an adequateopening in the wall for the wir...
Page 17 - Replacing the Bubble
Replacing the Bubble This section provides instructions for replacing a bubble on an AUTODOME 5000 camera. Parts List Quantity Item 1 Tinted Bubble with Trim Ring(with two (2) M3x23L Torx screws attached) 1 Torx Wrench 1 Installation Manual 6 6.1 AUTODOME 5000 PTZ Camera Replacing the Bubble | en 17...
Page 18 - Installing the Replacement Bubble
Installing the Replacement Bubble Use the illustration below as a guide for replacing the bubble. 1 2 3 1 Safety Tab with M3x5 Screw 2 Bubble Assembly 3 M3x23L Screw (2 pieces) 6.2 18 en | Replacing the Bubble AUTODOME 5000 PTZ Camera 2013.07 | 1.3 | Installation Guide Bosch Security Systems, Inc.
Page 20 - Technical data; Camera Dimensions
Technical data Camera Dimensions 295.5 (11.63) 218.38 (8.6) 81.9 (3.22) mm (in.) 208 (8.19) 187 (7.36) Figure 7.1: AUTODOME 5000 Indoor/Outdoor Dimensions 1 Diameter without sunshield (indoor models) 2 Diameter with sunshield (outdoor models) 7 20 en | Technical data AUTODOME 5000 PTZ Camera 2013.07...