Bogen MCPB - Manual - manualsarea.com

Page 2 - IMPORTANT

2 Notice Every effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subject to change. Important Safety Information WARNING: To Reduce The Risk of Fire Or Electric Shock, Do Not Expose This Apparatus To Rain Or Moisture...

Page 3 - Contents

3 Contents SYSTEM DESCRIPTIONS ..................................................................................................4 Series 11 5B ..........................................................................................................................................4 Series 2223R &am...

Page 4 - System Descriptions

4 System Descriptions Series 11 5B The Bogen Multi-Graphic Series 11 5B Centralized School Sound Systems provides separate program and intercom channels to permit intercommunication with any speaker-equipped location, without interrupting the distributionof program material to the remaining stations...

Page 5 - Options; LPC4 Loop Priority Control Option

5 Options LPC4 Loop Priority Control Option The LPC4 is used to interface the school sound system with satellite systems, such as those found in gymnasiums,multi-purpose rooms, etc. The option also provides emergency seizure of the satellite system and bridging of theiroutputs into the main system. ...

Page 6 - Connections; Operation

6 ASF4 Alarm-Signaling Option The ASF4 option provides four distinct tones for use as a manually-operated class change or for alarm signaling pur-poses (slow whoop, chime, steady, and interrupted tone). Tones are activated by remote contact closure. (Note: Ifthe MCP35A built-in tone signal generator...

Page 8 - SCT Six-Circuit Time Signaling Option

8 SCT Six-Circuit Time Signaling Option The SCT option is used with the 6-circuit master clocks and the Bogen TZMA Time Zone Relay module, to provideautomatic distribution of class change signals. Class change signal interrupts programming only at those speakersprogrammed, via the TZMA, to receive t...

Page 9 - MCPB Program Control Panel

TWK35 1 and TWK354 Two-Wire Call-in Options The TWK35 1 (Series 11 5B, 2223R) and TWK354 (Series 2233R) are used only with the CA 1 0A Call-in Switches to allow light annunciated call-in with 2-conductor shielded cable. Refer to Figure 5. Note: Do not use SCR25A with 2-wire call-in. Refer to MP35A I...

Page 10 - Installation; Accessory Connector; Interconnections

10 Installation Caution: Installation of the MCPB requires removal of equipment covers, exposing the risk of electrical shock. Unauthorized modification can also void the warranty. For this reason, installation should be performed by quali-fied service individuals only. Accessory Connector An Access...

Page 11 - Technical Specifications; Phantom Power

11 Rated Output: B Program – 1 .8V into Hi-Z load (line out to booster) Note : The output is unbalanced; nominal output impedance is 5.6 kilohms Frequency Response (at rated output) B Program – MIC Inputs: Shaped for maximum intelligibility (-3 dB @ 300 Hz and 1 5 kHz); AUX Input: + 1 , -3 dB from 8...

Page 12 - Limited Warranty Exclusion of Certain Damages

50 Spring Street, Ramsey, NJ 07446, U.S.A. Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com The Bogen Multi-Graphic is warranted to be free from defects in material or workmanship for two (2) years from the date of saleto the original purchaser. Any part of any Bogen product covered by this warra...

Bogen MCPB - Manual

Table of Contents:

Summary

Other Bogen Models