Bogen HFCS1LP - Manual
Bogen HFCS1LP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Product Diagrams; . Coaxial Driver Assembly; Rear Drawing
- Page 4 – Installation; IMPORTANT
- Page 5 – Speaker Wiring; Speaker Polarity
- Page 7 – Specifications
- Page 8 – Accessories; Limited Warranty
© 2006 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-209
1
-0
1
C 06
1
0
High-Fidelity
Ceiling Speakers
Models HFCS1
and HFCS1LP
Installation and Use Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Product Diagrams Front Drawing (grille removed) 1 . Coaxial Driver Assembly 2. Bass Tuning Vents (x2, HFCS 1 , x 1 , HFCS 1 LP) 3. Grille Retention Groove 4. Power Tap Selection Switch 5. Mounting Clamp Screws (x4) Rear Drawing 6. Metal Back Can 7. Snap-Lock Input Connector 8. Mounting Clamps (x4) R...
Installation The HFCS 1 and HFCS 1 LP can be installed in a variety of ceiling environments. The use of the TBCR (Tile Bridge Support Ring) accessory may be desired for many ofthese. For suspended ceilings, the use of a TBCR is strongly recommended tohelp support and distribute the weight of the spe...
Speaker Wiring All wiring should be done prior to installationand then plugged into the rear of the speaker.Wiring is terminated at a snap-lock input con-nector. There are two positive and two nega-tive terminals to accommodate daisy-chainingof speakers in a system. Daisy-Chaining The snap-lock inpu...
