Bogen CSUB - Manual - manualsarea.com

Page 3 - Product Diagrams; Grille Retention Groove; Side Drawing; Safety Tether Point

Product Diagrams Front Drawing (grille removed) 1 . Driver Assembly (internal) 2. Bass Tuning Vent 3. Grille Retention Groove 4. 24 " Ceiling Tile Guide Arrows (×2) 5. Power Tap Selection Switch 6. 1 4- 1 /2 " Joist Space Guide Arrows (×2) 7. Mounting Clamp Screws (×4) Side Drawing 8. Metal ...

Page 4 - Speaker Placement; Three possible locations for a CSUB Subwoofer; ensure that mounting clamps are properly extended (see

4 Speaker Placement The low frequency capability of the CSUB allows great flexibility in its placement. Whilefull-range speakers will typically be installed throughout the ceiling in an evenly spreadpattern, the CSUB can be placed wherever it is most convenient. This usually meanswhere the subwoofer...

Page 5 - IMPORTANT; There must be a minimum of; front; of the mounting surface and any other; Installation

5 IMPORTANT There must be a minimum of 11 " of vertical clearance ( 1 2- 1 /4" if using the CK 1 0 Safety Cable Kit) between the front of the mounting surface and any other structure in the ceiling for the speaker to fit. Before cutting the full hole, inves-tigate for depth and clearance by ...

Page 6 - Product; for this installation.

6 Installation (cont.) SUSPENDED CEILINGS: 1 . Remove the ceiling tile from the ceiling grid. Cut a 1 4- 1 /4" circular hole in the ceil- ing tile. Use the included template as a guide. 2. Put the CSUB face down on a workbench or on the floor without grille installed . 3. Place the ceiling tile ...

Page 7 - DRYWALL OR OTHER HARD SURFACES:; ed template as a guide.; To help; guides for this installation.

7 Installation (cont.) DRYWALL OR OTHER HARD SURFACES: 1 Be sure you know the location of the ceiling joists before cutting the speaker open- ing. Cut a 1 4- 1 /4" circular hole where the CSUB will be installed. Use the includ- ed template as a guide. 2. Make electrical connections to the snap-l...

Page 8 - Speaker Wiring; will disable all speakers further down the chain.; Speaker Polarity

8 Speaker Wiring All wiring should be done prior to installation andthen plugged into the rear of the speaker. Wiring isterminated at a snap-lock input connector. Thereare two positive and two negative terminals toaccommodate daisy-chaining of speakers in a sys-tem. Daisy-Chaining The snap-lock inpu...

Page 10 - CK

10 Specifications * Half-space response (ceiling-mounted), 8-ohm input † Front panel, switch-selected Accessories CK 1 0 ( 1 0-Ft. Safety Cable Kit) The CK 1 0 is a 1 0-foot cable with one looped end and an adjustable cable clamp. It is suitable for use as a safety cable. On the CSUB Ceiling Subwoof...

Page 11 - Limited Warranty Exclusion of Certain Damages

11 The Bogen Ceiling Subwoofer, model CSUB, is warranted to be free from defects inmaterial or workmanship for three (3) years from the date of sale to the original purchas-er. Any part of the product covered by this warranty that, with normal installation and use,becomes defective will be repaired ...

Bogen CSUB - Manual

Table of Contents:

Summary

Other Bogen Models