Bogen BDT30A - Manual

Watts (70V)

1

.8

3.7
7.5

1

5

30

*
*

Speaker Installation

Bi-Directional Reentrant
Horn Loudspeaker

Specifications subject to change without notice.
© 2000 Bogen Communications Inc. All rights reserved.
Part No. 54-584

1

-0

1

r2 Printed in Korea 0003

Speaker Assembly

The bi-directional speaker must be assembled prior to installation. See Figure

3

on the back of this sheet for speaker assembly

information. Make sure to place the washer/seals where indicated and hand tighten the various components -

do not use pliers

or similar tools.

STEP

1

-

For easier installation, remove the flange (base) from the speak-

er by unscrewing the wing nut while at the same time pressing inwardly on
the wing nut. Place the flange flush with the mounting surface and mark the
location of the three holes with either a marker or punch. It is important
that the three holes be exactly aligned with the flange, otherwise you might
stress the base or make the connection unsteady (see Figure

1

).

NOTE:

Speaker may also be strap-mounted through the slot in flange (base)

using standard

1

/2-inch industrial strapping (not included).

STEP 2 -

After mounting the flange, reattach the speaker to the flange and

aim the speaker for the desired coverage. A 45

o

downward angle is rec-

ommended, but this may vary depending upon speaker layout. Unless oth-
erwise indicated, do not aim speakers directly at each other or poor paging
intelligibility may occur.

STEP 3 -

Remove the plastic cover to make the electrical connection and

set the tap set control (see Figure 2). Connect speaker wire shield to the
ground (GND) terminal of the amplifier’s output. Carry the ground through
all speaker cables by tying the shields of the speaker cables together in a
“daisy chain” fashion.

Do not connect the shield to the speaker itself.

The shield is only connected at the amplifier end and simply floats.

Connect wires as listed below:

Amplifier Outputs Speaker Connections

70V/25V Terminal

1

COM

Terminal 2

NOTE

: The speaker will also work perfectly well with these connections reversed.

However, reduced low frequency response may result.

STEP 4 -

Adjust the tap set control to the desired setting. See table at right

for tap settings. Replace the plastic protective cover back over the exposed
area.

Frequency Response:

225Hz to

1

4kHz

Dimensions:

1

6-

1

/2”W x 9-3/4”H (4

1

.9 x 24.8 cm)

Shipping Weight:

9 lbs.

Finish:

Textured Mocha Enamel

Sound Pressure Level:

1

2

1

dB @ four feet on axis with 30-watt input

at

1

000Hz each horn

Figure 2

ELECTRICAL
CONNECTION

TAP SET
CONTROL

Page 1 of 2

Figure 1: Mounting Speaker Base

Position

1

2
3
4
5
6
7

Watts (25V)

.25

.5

1

1

.8

3.7
7.5

1

5

*Forbidden switch settings (see text)

CAUTION

Switch settings marked with an asterisk (*) must not be

used. Failure to comply with these restrictions may cause

damage to components and will void the warranty.

8

*

*

BDT30A Manual