Belkin F5D5141-24 - Manual

Front-Panel LEDs Belkin 16- or 24-Port Gigabit Switches feature two rows of LEDs that provide information about connection speed, link/activity, plus a separate Power LED. ���������������������� (a) Power (POWER) LED • Green – Power on, normal operation • Off – Power off, no power to the Switch (b) ...

5 Connecting Networking Devices to your Switch 5 se ct io n 1 2 3 4 5 6 7 8 Connecting your Switch to another Switch1. Connect a Category 5e or 6 cable between one of the numbered ports on the front of the Switch and one of the numbered ports on the other Switch to which you are cascading or connect...

7 6 Applications This Switch segments your network, significantly increasing both bandwidth and throughput. Each port on the Switch can be attached to any Ether net, Fast Ether net, or Gigabit Ether net device, such as another switch, or a server’s network adapter. All ports operate at 10/100Mbps fu...

7 The Switches can be placed on a flat surface or in a 19-inch rack. Placement on a Flat Surface1. Affix the four included rubber feet on the bottom of the Switch in the area that is clearly marked on each of the four cor ners. 2. Make sure the Switch is placed in an area that allows for proper vent...

9 8 Product Specifications 9 8 Product Specifications Physical Characteristics Standards Conformance IEEE Std 802.3-2002 Communication Rate 10-, 100-, and 1000Mbps Communication Mode Full or half duplex at 10/100MbpsFull duplex at 1000Mbps Media Supported 10Base-T: 100-Ohm Category 3 orbetter twiste...

9 Product Specifications 9 se ct io n 1 2 3 4 5 6 7 8 Switching Criteria Network Bridging Function Filtering, forwarding, and lear ning Switching Method Store-and-forward MAC Address Table F5D5141-16: 8K entries F5D5141-24: 8K entries Packet Buffer F5D5141-16: 320Kb F5D5141-24: 480Kb

11 10 Troubleshooting 11 10 Troubleshooting Diagnosing Switch Indicators Symptom Power LED does not light after power on. Probable Causes AC power cord may be defective. Possible Solutions • Check for loose connections. • Check the power outlet by using it for another device. • Replace the AC power ...

11 Troubleshooting 11 se ct io n 1 2 3 4 5 6 7 8 Power and Cooling Problems If the power indicator does not tur n on when the power cord is plugged in, you may have a problem with the power outlet, power cord, or inter nal power supply as explained in the previous section. However, if the unit power...

13 Information 13 se ct io n 1 2 3 4 5 6 7 8 RFI Emission: • Limit class A according to EN 55022:1998, IEC 60601-1-2 (EMC, medical) • Limit class A for harmonic current emission according to EN 61000-3-2/1995 • Limitation of voltage fluctuation and flicker in low-voltage supply system according to E...