Beefeater BB18326 - User Manual

BUGG BBQ NATURAL GAS

CONVERSION KIT

Kit Model 95140 includes:

2 x 1.50mm injectors (Part No. 040261)
2 x 1.83mm injectors (Part No. C090015NG Bigg Bugg Only)
2 x Aeration shutters (Part No. A04722501 Bigg Bugg Only)
1 x Natural Gas Label (020404)
1 x Hose and Regulator assembly (Part No. 95162)
1 x Restraining Cable (95111)
1 x Instructions 020686

Look here for

identification reference

Please read the user manual carefully and store in a handy

place for later reference.

Important Safety Instructions

WARNING

WARNING

All service to the appliance must be undertaken by a

qualified gas service agent.

Do not smoke or use a naked flame within the vicinity of the

appliance or gas line when performing gas conversion or

service of any kind.

Always carry out a gas leak test after any work has been

carried out on the appliance.

If your barbecue is fitted with an optional side burner, gas

conversion must be carried out at the same time.

Always use the correct size socket spanner / wrench to

remove or replace the gas injectors. Do not use pliers or

any other type of tool that may squeeze the head of the gas

injector. This may cause the gas orifice to change shape

thereby adversely affecting the gas flow to each burner.

Gas injectors are made of brass and have a fine thread which

must be treated with care when being handled. Remove and

replace injectors with care.

WARNING

WARNING

The manufacturer accepts no responsibility for any

consequential damage, malfunction or loss due to incorrect

conversion of installation.
FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID

THE APPLIANCE WARRANTY.

WARNING

BIGG BUGG

INSTRUCTIONS FOR BIGG BUGG NATURAL GAS

CONVERSION ARE DETAILED IN THE BIGG BUGG

MANUAL SUPPLIED WITH THIS BBQ. FAILURE TO

FOLLOW THOSE INSTRUCTIONS WILL VOID THE

APPLIANCE WARRANTY

Remove and Replace Gas Injectors (Jets)

1. Turn off the gas supply valve on the gas cylinder. Ensure

that all gas controls are in the OFF position.

2. Disconnect the hose and regulator from the gas cylinder

and disconnect the gas hose from the barbecue gas inlet

using a 19mm open-ended spanner / wrench.

3. Open hood and remove the cooking plate and grill from

the BBQ.

4. Remove each burner by unscrewing the 3 screws

holding it to the body.

5. The gas injectors (Jets) for each burner are located

within deep pockets at the rear of the BBQ.

6. Remove each gas injector from the end of each jet

holder, turning gently in a counter clockwise direction.

Ensure the jet holder is firm and won’t turn while

unscrewing the nozzle.

7. Check the identification mark stamped on the Hex Head

of the injector to confirm that it is the correct size –

1.50mm. Screw correct Jets back into place.

8. When fitting the NG gas injectors to the end of the jet

holder be sure to seat the injector correctly on the

thread before turning it in a clockwise direction until it is

seated firmly in place. Do not over-tighten.

NATURAL GAS CONVERSION INSTRUCTIONS