Page 2 - Australia’s Leading Barbecue; Beefeater Barbecues; serious bodily injury or damage to property.; Table of Contents; Important; These specifications must be left with the owner.; USA; Operation
Australia’s Leading Barbecue 2 Beefeater Barbecues WARNING: We want you to enjoy your barbecuing experience - Failure to follow the instructions and observe the warnings provided in this operating manual could result in serious bodily injury or damage to property. NOTE TO INSTALLER: This manual must...
Page 3 - BeefEater Barbecues; DO NOT
Australia’s Leading Barbecue BeefEater Barbecues 3 Precautions and Warnings DO NOT • Lean over barbecue when lighting.• Leave cooking food unattended.• Delay lighting burners after turning gas on.• Spray or store aerosols in vicinity of barbecue whilst in operation. • Store combustible materials, ga...
Page 4 - Gas Cylinder Safety Information; Hose and regulator replacement must be a; Gas Leak Test Procedure; Use the following procedure to check for gas; Gas Cylinder Information
Australia’s Leading Barbecue 4 Beefeater Barbecues Gas Cylinder Safety Information This appliance is designed to be used with a gas cylinder not exceeding 9KG (20lbs) capacity.The Gas cylinder must be constructed and marked in accordance with specifications for LP Gas Cylinders of the:(USA) U.S. Dep...
Page 5 - For Your Safety; Tools Required
Australia’s Leading Barbecue BeefEater Barbecues 5 For Your Safety If you smell gas:1. Shut off gas to the appliance.2. Extinguish any open flame.3. Open lid.4. If odour continues, immediately call your gas supplier or your fire department. For Your Safety 1. Do not store or use gasoline or other fl...
Page 6 - Assembly Notes; Heat Reflectors, Burners And Vaporizers; Model
Australia’s Leading Barbecue 6 Beefeater Barbecues Assembly Instructions Fig 6 Fig 7 Upper slots for Vaporizers Lower slots for heat reflectors Assembly Notes Before any assembly or installation is attempted it is important that you check for damage or missing parts. Your dealer or the manufacturer ...
Page 7 - Fitting The Heat Reflectors
Australia’s Leading Barbecue BeefEater Barbecues 7 Assembly Instructions Fitting The Heat Reflectors Completely remove all of the plastic film from the reflectors. The tabbed ends of the heat reflectors face forward to the front of the barbecue frame. The tabs fit into the slots in the front end of ...
Page 8 - Fitting The Grease Tray; Assembly Instructions; Fitting The Cooking Plates And Grills; Fig 13 Rear of Barbecue
Australia’s Leading Barbecue 8 Beefeater Barbecues Fitting The Grease Tray Neatly line the drip tray with a couple of sheets of aluminium foil. Cut the foil to shape and make sure that the foil sits on the bottom of the tray or corners of the foil so that it does not foul in the tray sliders on the ...
Page 9 - The flexible PVC hose assembly supplied must not be
Australia’s Leading Barbecue BeefEater Barbecues 9 Installation Instructions Important This appliance must be installed in accordance with the installation requirements of the LOCAL GAS and ELECTRICITY supply authority, or the appropriate installation code issued by the A.G.A. and the A.L.P.G.A. Ser...
Page 10 - Before Lighting; Note; To Turn Off The Burner
Australia’s Leading Barbecue 10 Beefeater Barbecues Operating Instructions Before Lighting 1. Check that all gas hose fittings and connections are spanner tight. Gas regulators that are fitted with a hand tightening wheel should be checked to ensure that the connection is secure. 2. Check that contr...
Page 11 - burner barbecue
Australia’s Leading Barbecue BeefEater Barbecues 11 Operating Instructions Manual Lighting 1. Press and turn the left hand control knob counter- clockwise to the “High” position, then light the left hand burner immediately through the gap between the front of the drip tray and the barbecue body. Not...
Page 12 - Operation Of The Optional Side Burner; Lighting; After Use; Keep children away from the appliance when it is operating.
Australia’s Leading Barbecue BeefEater Barbecues 12 Operating Instructions Operation Of The Optional Side Burner Lighting 1. Check the control knob is in the Off position and ensure the gas line is properly connected. 2. Raise the lid and check that the burner and burner cap are in the correct posit...
Page 13 - Attach The Hood Top To The Hood Base ( If required); Attach The Hood To The Barbecue; Hood Assembly Instructions
13 Attach The Hood Top To The Hood Base ( If required) The tabs on the bottom of the hood base slip into slots on the sides of the barbecue frame.It is best to do this with a 3 stage manoeuvre:1. Tilt the front of the hood into the slots, 2. Lower the back till the hood sits flat, 3. Push the hood b...
Page 14 - Getting The Most From Your Roasting Hood
14 Wash the roasting hood thoroughly with warm soapy water or an approved non-abrasive cleaner before use. On stainless steel models use a suitable stainless steel cleaner to remove all fingerprints prior to lighting and operating your barbecue. If not removed, fingerprints will discolour the steel....
Page 15 - Type of Meat; Maintaining The Right Cooking Temperature
15 Most importantly, do not allow your barbecue to overheat. Your hood is designed to keep the heat in, and so requires constant monitoring. Do not use more than 2 burners on high at any one time. As a guide, for a 4 burner barbecue in moderate weather: Two burners on low produces 150°C/300°F Two bu...
Page 16 - Problem; How Long Will The Gas In My Cylinder Last?
Australia’s Leading Barbecue 16 Beefeater Barbecues Help Guide Your BeefEater barbecue has undergone a series of quality checking points prior to leaving the factory. Should you have a problem with your appliance please refer to the help guide below before calling your dealer or service person. Impo...
Page 17 - Cleaning The Cooking Surfaces; Care and Maintenance; Care And Maintenance Instructions
Australia’s Leading Barbecue BeefEater Barbecues 17 Cleaning The Cooking Surfaces Each system has specific care, cleaning and maintenance requirements so it is important to read the correct instructions for the system supplied with your barbecue. Standard Cast Iron Grills - Non Porcelain Coated Many...
Page 18 - General Care And Maintenance Instructions; Stainless Steel Cleaning And Maintenance
Australia’s Leading Barbecue 18 Beefeater Barbecues Care and Maintenance • Coat the grills with a layer of cooking oil. This will protect the grills between barbecuing sessions. . Do not clean the cooking grills in a dishwashing machine. • Do not use highly caustic, harsh or abrasive chemical cleane...
Page 19 - Condition; Do; Porcelain Enamel Cleaning And; Service And Maintenance
Australia’s Leading Barbecue BeefEater Barbecues 19 Condition Cleaning Agents Precautions Non washable deposits Heavy grease Soap, Liquid Detergents, or Powder Detergents with warm water. Methylated Spirits may be used before final wash with detergent. Concentrated Detergent. Domestic cleaning powde...
Page 20 - Outdoor Installation Instructions
Australia’s Leading Barbecue 20 Beefeater Barbecues Barbecue Width Outdoor Installation Instructions We recommend that this installation be done in a masonry structure and carried out by a professional tradesperson. Other non-combustible material such as Hardiplank, Villaboard with metal studs may a...
Page 23 - Signature S3000E Series (Porcelain Enamel); Signature S3000S Series (Stainless Steel)
Australia’s Leading Barbecue BeefEater Barbecues 23 Signature Series Spare Parts Signature S3000E Series (Porcelain Enamel) Ref # Description 2 BNR 3 BNR 4 BNR 5 BNR Code QTY Code QTY Code QTY Code QTY Barbecue 20022 20032 20042 20052 1 Barbecue Frame 120007 1 130008 1 140009 1 150002 1 2 Grease tra...
Page 25 - Without Viewing Glass; With Viewing Glass; Black Porcelain
25 Without Viewing Glass Black Porcelain Stainless Steel 2B 3B 4B 5B 2B 3B 4B 5B 29622 29132 29142 29152 29420 29430 29440 29450 P# Description Part Code Part Code Part Code Part Code Part Code Part Code Part Code Part Code QTY 1 Hood Body Top 320005 330005 340007 350007 320107 330106 340109 350111 ...
Page 26 - BeefEater Barbecues Warranty Terms; ARRANTY
Australia’s Leading Barbecue 26 Beefeater Barbecues Warranty Terms and Conditions Signature S3000E & S3000S Series Warranty Terms Signature S-3000S Stainless Steel Signature S-3000E Porcelain Enamel Barbecue Barbecue Frame Lifetime 10 Years Cast Iron Burners 5 Years 5 Years Valves 5 Years 5 Year...
Page 27 - Warranty Terms and Conditions
Australia’s Leading Barbecue BeefEater Barbecues 27 Should any part fail due to defective workmanship or faulty materials within the specified period from the date of purchase, BeefEater or its distributor will repair or, (at distributors option), replace the defective part free of charge. • RF Tech...
Page 28 - Tech Support
Australia’s Leading Barbecue 28 Beefeater Barbecues Accessories BeefEater Sales International3-5 Birmingham Avenue P.O. Box 236Chester HillN.S.W. Australia 2162 PH: +61 2 9724 8888 FAX: +61 2 9724 8889 USA: Toll Free 1.866.550.2333 E-mail: [email protected] Website: www.beefeaterbbq.com Document Ref...