Beckett M250A - Manual
Beckett M250A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MAINTENANCE; IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:; Check the pump discharge, impeller and tubing for obstructions.
- Page 3 – MANUAL del PROPIETARIO de la BOMBA SUMERGIBLE; ADVERTENCIA; Riesgo de choque eléctrico
- Page 4 – Desconecte siempre de la toma eléctrica antes de tocar la Bomba.; Bomba recibe alimentación eléctrica.
- Page 5 – GUIDE D’UTILISATION de la POMPE SUBMERSIBLE; AVERTISSEMENT; Risques d’électrocution :; les risques de chocs électriques.
- Page 6 – ENTRETIEN; Débranchez toujours la Pompe avant de la manipuler ou de; Employez un courant d'eau pour enlever n'importe quels débris.
- Page 8 – BECKETT CORPORATION
CZ8697
Rev. D
SUBMERSIBLE PUMP OWNERS MANUAL
Models: M250A & M400A
This pump is carefully inspected and tested to ensure both safety and operating performance. The
Pump is manufactured for continuous duty usage. Failure to follow these instructions and warnings
may result in pump damage and/or serious injury. Be sure to save this manual for future reference.
R
Drip Loop
WARNING
•
Risk of electrical shock,
this pump is supplied with a grounding conductor and a grounding type
attachment plug.
To reduce risk of electrical shock
, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
•
To reduce the risk of electric shock,
use the pump with the flow control only on portable self-contained
fountains no larger than 5 feet in any dimension.
•
The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the branch
circuit supplying fountain pumps and other pond equipment. See your electrical supplies dealer for this
device.
•
Do not remove grounding pin from the plug.
•
Do not connect to any voltage other than that shown on the pump.
•
To reduce risk of electrical shock
, always disconnect from power outlet before handling pump or putting
your hands into the water.
•
Do not let pump run dry.
•
Operate in non-heated fresh water only. Ensure that the pump is completely submerged for proper cooling
to assure the pump’s life.
•
Do not remove the pump by pulling the power cord.
•
Power cord cannot be replaced; pump should be discarded if any cord damage occurs.
•
Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent
water from running down the cord into the electrical outlet.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MAINTENANCE CAUTION: Always disconnect from the electrical outlet before handling the Pump. IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING: • Check the circuit breaker and try another GFCI protected outlet to ensure the Pump is getting electrical power. • Check the pump discharge, impeller and tu...
MANUAL del PROPIETARIO de la BOMBA SUMERGIBLE Modelos: M250A y M400A Series Esta bomba se ha examinado y probado cuidadosamente para seguridad y funcionamiento. Fabricada para uso continuo. Sin embargo, el no seguir las instrucciones y advertencias de este manual puede dar como resultado que la bomb...
MANTENIMIENTO CUIDADO : Desconecte siempre de la toma eléctrica antes de tocar la Bomba. SI LA BOMBA NO FUNCIONA, REVISE LO SIGUIENTE: • Revise el fusible del circuito y pruebe otro tomacorriente (GFCI) para asegurarse de que la Bomba recibe alimentación eléctrica. • Revise la boca de descarga, impu...
