BEA Superscan - Manual
BEA Superscan – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – COMMON INDUSTRIAL APPLICATIONS; DOORS THAT OPEN TO TWO DIFFERENT HEIGHTS:
- Page 4 – SUPERSCAN INSTALLATION PROCEDURES; Mounting the aluminum extrusion to a door jamb or wall.
- Page 5 – ON SITE ADJUSTMENTS; RX = Receiver TX = Transmitter
- Page 6 – Adjustment of the Detection Distance; Also set to Normal Mode if using; Function J2: Relay Mode
- Page 7 – Potentiometer P1: Hold Time; HINGE SIDE RIGHT HINGE SIDE LEFT; detection distance
- Page 8 – Wiring Connections for Industrial Use
SUPERSCAN
INFRARED PRESENCE BEAM
INSTRUCTION MANUALFOR INDUSTRIAL APPLICATIONS
We can be reached from anywhere in the world:
US & Canada Toll Free 800-523-2462 (EST)
US & Canada Toll Free 877-232-9378 (PST)
Mexico Toll Free 001-800-711-1398
Latin America 412-782-5191
Email: [email protected]
B.E.A., Inc.
••••
300 South Main Street
••••
Pittsburgh PA 15215
••••
USA Tel. 412-782-5150
••••
Fax 412-782-5154
This manual may be downloaded from our web site in PDF format: www.beainc.com
Requires Adobe Acrobat Reader.
75.1035 V1 Feb 2001
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
75.1035 V1 Feb 2001 Page 3 of 8 COMMON INDUSTRIAL APPLICATIONS : DOORS WHERE OVERHEAD ACTIVATION SENSORS ARE NOT ABLE TO BE MOUNTED: For applications with limited mounting height using an IS-87 for activation for vehicles only, the SuperScan can be installed as shown to the left and wired in series ...
75.1035 V1 Feb 2001 Page 4 of 8 SUPERSCAN INSTALLATION PROCEDURES **B.E.A. sensors, as with all automatic door equipment, should be set up and inspected in accordance with applicable ANSI standards. Mounting the aluminum extrusion to a door jamb or wall. 1. Remove the screws and end caps and snap th...
75.1035 V1 Feb 2001 Page 5 of 8 ON SITE ADJUSTMENTS 1. Position of the Master and Slave Modules in the Aluminum Extrusion NOTE: RX = Receiver TX = Transmitter Please use the above diagrams for the terminology used to describe the installation of the SuperScans. The position of the master and slaves ...
