B&B Electronics 485 RF - Manual
B&B Electronics 485 RF – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Requirements for Range Test; Introduction; Install X-CTU Software; Loopback; by looping data back into the modem for retransmission. [Figure 1]; RPSMA antennas; Range Test Setup; NEMA; CAT5 cable
- Page 3 – Range Test Procedure; Range Test; Figure 3 Range Test tab; Figure 2. PC Se�ings tab; Setup a PC Serial Com Port for communications with the
- Page 4 – Optional Configurations; Restoring Modem Defaults; Contact MaxStream; Using the RF Modem DIP Switch; Figure 4. DIP Switch Se�ings (Se�ings applied only when powering on); To Restore Defaults
Quick Start Guide
Introduction
Range Test Setup
Range Test Procedure
Optional Configurations
www.maxstream.net
© 2005 MaxStream, Inc. All rights reserved.
MD0025
Create a long range wireless link in minutes.
9XTend-NEMA™ Weatherproof RS-232/485 RF Modem
WARNING: When operating with 1 Watt power output, transmitting in close
proximity of other RF modems can damage modem front-ends. Observe a minimum
separation distance of 2' (0.6 m) between modems.
Refer to the 9XTend-PKG-R RS-232/485 product manual for information regarding
operation of the 9XTend-NEMA RF Modem.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Requirements for Range Test 1 XTend-NEMA Weatherproof RS-232/485 RF Modem1 XTend-PKG-R RS-232/485 RF Modem (or a second XTend-NEMA)1 PC (Windows 98 SE, 2000 or XP) loaded with X-CTU SoftwareAccessories (CAT5 cable with DB-9/PWR adapter board, loopback adapter, 2 RPSMA antennas (one is inside the NEM...
2 3 Use the "PC Settings" and "Range Test” tabs of the X-CTU Software to: • • Range Test Procedure Range Test PC Com Port Default Values Default RF data rate is 9600 baud Other Default Values: Flow Control = None Data Bits = 8 Parity = None Stop Bits = 1 Figure 3 Range Test tab 5 6 Start...
Optional Configurations Out-of-box, the XTend-NEMA RF Modem is configured to provide immediate wireless links between devices. The modem's default configuration supports a wide range of RF communications.If the RF Modem must be configured to support specific needs of a data system, many programming ...
