Barco R9855510 - Manual - manualsarea.com

Page 5 - Table of contents; TABLE OF CONTENTS

Table of contents TABLE OF CONTENTS 1. Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1.1 General instructions . . . . . . . . . . . ...

Page 7 - Safety instructions; SAFETY INSTRUCTIONS; Overview; General instructions; Caution

1. Safety instructions 1. SAFETY INSTRUCTIONS Overview • General instructions • Important Safety instructions • Safety instructions for LED screen setup • Safety instruction when driving the trailer • Important Warnings • Specific warnings for diesel-fueled generator • Specific warning for the jocke...

Page 8 - Important Safety instructions; Safety instruction when driving the trailer

1. Safety instructions 1.2 Important Safety instructions Instructions: • Read these instructions. • Keep these instructions. • Heed all warnings. • Follow all instructions. • IMPORTANT, plug holder clamps must be locked firmly on all controller units and power boxes to prevent the possible ingressof...

Page 9 - Important Warnings; Specific warnings for diesel-fueled generator; Specific warning for the jockey wheel

1. Safety instructions 1.5 Important Warnings Important warnings • High leakage current: The combination of multiple tiles in an installation results in increased levels of leakage current. In order to avoid risk of electricshock due to high leakage current, proper grounding of the installation is r...

Page 13 - Introduction; B-10 Mobile LED tiles; Functionality

2. System Overview 2. SYSTEM OVERVIEW Overview • Introduction • B-10 Mobile LED tiles • LED Pro • B-10 Mobile LED trailer • B-10 Mobile LED generator 2.1 Introduction Overview The B-10 Mobile LED is a mobile outdoor LED display solution. The LED-wall comes in a trailer that can be pulled by a vehicl...

Page 15 - Dimensions SLite XP tile

2. System Overview D320 input compatibility S-Video, Composite, YUV, RGB, SDI, HDSDI, Data DVI up to UXGA Certifications ETL, CE, CEBEC, TUV, FCC class A Tile dimensions width: 896mm (35.3") height: 672mm (26.5") depth: 248mm (9.8") Order Information R9004170 2.2.3 Dimensions SLite XP ti...

Page 16 - LED Pro

2. System Overview B C A D E Image 2-4SLite input/output ports. A Connection module. B Power input port. C Power output port. D Data input port. E Data output port. A Image 2-5 A Plug holder clamp. C AUTION : The SLite input/output ports can only be used in conjunction with Barco’s outdoor cables fo...

Page 17 - B-10 Mobile LED trailer

2. System Overview Image 2-6LEDPRo 2.3.2 LED-PRo features Overview • Three universal inputs accept RGBHV/RGBCs/RGsB computer video, component video (STD or HDTV), SVideo, or compositevideo with loop-through • SD SDI/HD-SDI input. • DVI-I connectors support both universal analog and DVI input with lo...

Page 18 - B-10 Mobile LED generator

2. System Overview 2.4.2 Dimensions Overview 4240 21 12 2500 2385 2688 3584 Image 2-7Dimensions 2.5 B-10 Mobile LED generator 2.5.1 Introduction Overview Please read this section carefully before using the generator. If you act as stated in this section, your generating set will guaranteeyou a smoot...

Page 21 - Starting and using the generator; Starting the engine; Charging the generator

2. System Overview On the inside of the control panel there can be found: • 2 x relay 12V/30A for guarding oil pressure and temperature of cooling liquid with aid of a stopping coil (Engine shuts off whenthe oil pressure is low or the temperature of the cooling liquid is to high). • 1 x relay 12V/30...

Page 25 - Installation of the B-10 Mobile LED; Useful tools; Powering the B-10 Mobile LED

3. Setup of the B-10 Mobile LED 3. SETUP OF THE B-10 MOBILE LED Overview • Installation of the B-10 Mobile LED • Powering the B-10 Mobile LED • Extending the LED display • Rotating the LED display • Move down the LED Display • Preparing for departure 3.1 Installation of the B-10 Mobile LED Useful to...

Page 26 - Extending the LED display; Extending process

3. Setup of the B-10 Mobile LED Image 3-2Contact key and power cable of pump 2. After several seconds turn-on the generator with this contact key. Caution: The generator of the B-10 Mobile LED needs to be well-ventilated. Therefore, the generator of the B-10 Mobile LEDis not indented to run for a lo...

Page 27 - Fastening both display halves together; Extending the full display

3. Setup of the B-10 Mobile LED Image 3-3Pump system 2. Push on the black button. 3. Lift the first halve of the LED-wall by using the lever Lift this part of the display up till its 10 cm above the deck of the B-10 Mobile LED. Fastening both display halves together 1. Release the 4 fasteners of the...

Page 28 - Rotating the LED display; Move down the LED Display

3. Setup of the B-10 Mobile LED Image 3-5Safety pieces Caution: Make sure the safety pins are placed in the mast. This is mandatory for security reason and to avoid that the mastcomes slightly down after closing the pump system. 3. Stop the pump system by closing the air arrival and switching off th...

Page 29 - Preparing for departure; Steps to be taken

3. Setup of the B-10 Mobile LED How to move down? 1. Lift down the display till it’s on the bottom. Note: Do not forget to take away the safety pieces from the mast. Caution: Watch out that cables are not under the display. 2. Open the pump system and lift up the display a little. 3. Close the pump....

Page 31 - Service and maintenance table

4. Maintenance, Service 4. MAINTENANCE, SERVICE Overview For maintenance, service and repair on the B-10 Mobile LED please consult qualified service technicians/personnel. Servicing is required when the B-10 Mobile LED has been damaged in any way, such as hydraulic mast or generator is damaged,the B...

Page 33 - Service and Maintenance of the Generator; Parts

4. Maintenance, Service Daily 500 km Quarterly Yearly C L T Cl C L T Cl C L T Cl C L T Cl cylinder flexible attachment to grid Generator general motor alternator oil gas - diesel exhausts fixing state C = Control L = Lubricate T = Tighten Cl = Clean After 50h00 the diesel generator needs to get its ...

Page 34 - Service intervals

4. Maintenance, Service Service intervals For a detailed explanation of the service intervals, consult the service and maintenance manual of the generator. Interval Items Every 50 hours • Check of fuel pipes and clamp bands After first 50 hours Change of engine oil A Cleaning of air cleaner element ...

Page 35 - Overview service center

4. Maintenance, Service Overview service center For Europe Country Engine (Kubota) Alternator (Leroy Somer) Austria MAG Motoren GmbH A-5023 Salzburg Tel. 43.662640460 Fax. 43.662882340 L-S Elektroantriebe GmbH A-1180 Wien Tel. 43.2224706401 Fax. 43.222479225 Belgium Matermaco S.A. 1030 Brussel - Bru...

Page 41 - A. Drawings B10 trailer; A. DRAWINGS B10 TRAILER; Electrical drawings

A. Drawings B10 trailer A. DRAWINGS B10 TRAILER A.1 Electrical drawings Overview Image A-1 R5976956 B-10 MOBILE LED 19/06/2007 37

Page 47 - Revision Sheet

Revision Sheet To: Barco nv Events/Documentation Noordlaan 5, B-8520 KuurnePhone: +32 56.36.89.70, Fax: +32 56.36.88.24E-mail: [email protected], Web: www.barco.com From: Date: Please correct the following points in this documentation ( R5976956/03 ): page wrong correct R5976956 B-10 M OBILE LED...

Barco R9855510 - Manual

Table of Contents:

Summary

Other Barco Models