Axis 290A - Manual
Axis 290A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – 90A Installation Instructions; front) and determine the camera’s correct position.; Routing the cables
- Page 3 – Installing the housing; the build-up of dust and moisture inside the housing.
- Page 4 – Two off centre
- Page 5 – Connecting the camera; for installation of the housing is 0.5 mm; Route the power cable through the; plug it into the network connector at the back of the camera.
- Page 6 – - plug the green power connector coming from the 12V DC power supply; Black
- Page 7 – Completing the installation; sufficiently to move the housing; Locking screw
- Page 8 – Maintenance; damaged seals should be replaced.; Specifications
1
290A Installation Instructions
Unpacking
In the box with the 290A housing you will find a small plastic bag containing:
No.
1.
One large allen key
2.
One small allen key
3.
Two locking screws
4.
Four M8 wall fixings
5.
Four plugs (11x50 mm) for use in solid walls
Fitting the camera inside the housing
Recommendation:
Fit the camera in indoor conditions to prevent the build-up of dust and
moisture inside the housing.
1. Open the housing by releasing the
two clips on the side.
2. Undo the two screws (6) on the
camera mounting board (7). Slide
the board backwards and lift it
out.
3. Refer to the Axis Installation
Guide provided with the Axis
camera for instructions on camera
hardware installation.
1
2
3
4
5
6
7
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 290A Installation Instructions 4. Attach the camera to the camera mounting board (7) using the screw attached to the board. You will find a screw hole at the bottom of the camera. Before tightening the screw, position the camera with the board inside the housing (with the lens to the front) and de...
3 290A Installation Instructions Installing the housing Recommendation: Keep the housing closed when possible during the installation to prevent the build-up of dust and moisture inside the housing. Important: This product should be installed by certified electrical technicians in compliance with lo...
4 290A Installation Instructions 6. Now position the widget (10) inside the swivel (11) with the cables coming through the opening. Match the F and R on the widget with the F and R on the swivel, assuring that F remains at the front and R at the back. 7. Line up the positioning bolt (13) with the sc...
