Asko HG1984S - User Manual

EN 7 What you should pay attention to • Ensure that there is adequate ventilation during use. • Keep natural ventilation openings open. • When using the hob for long periods, extra ventilation is necessary. Open a window for instance or install a mechanical fan. • Use the hob only for preparing dish...

EN 8 • Do not use the device as a worktop. The device may be switched on by accident or still be hot, which means objects could melt, become hot or catch fire. • Never cover the device with a cloth or something similar. If the device is still hot or is switched on, there is a risk of fire. • Be extr...

EN 9 CONTROLS Igniting and adjusting Each burner can be adjusted continuously between the high and low positions. 1. 0-setting 2. Burner indication 3. Low setting 4. High setting Flame failure device Your gas hob has a flame failure device. This ensures that the gas supply is shut off if the flame g...

EN 10 COMFORTABLE COOKING Optimal use of the hob Always ensure that the flames remain below the pan. If flames play around the pan, a lot of energy is lost. In addition, the handles can get too hot. Do not use pans with a base diameter less than 12 cm. Smaller pans will not be stable. • When frying,...

EN 11 MAINTENANCE General Your appliance has been manufactured from high-grade materials, which are easy for you to clean. • Regular cleaning immediately after use prevents over-cooked food being able to become ingrained and cause stubborn stains that are difficult to remove. Use a mild cleaning age...

EN 12 Assemble the burner parts using the guide ridges. Stubborn stains on enamel • Remove with a non-abrasive cream. Never use scouring powder, scouring pads, sharp objects or aggressive cleansing agents. MAINTENANCE 1. Burner cap outer ring2. External torch head3. Internal lid and torch head 4. Ga...

EN 13 MAINTENANCE Stubborn stains on stainless steel • If spilled, acid fluids and sugary foodstuffs like red cabbage, beetroot, soy sauce, applesauce and rhubarb may cause the surface to discolour. Stubborn stains on stainless steel are best removed with a cleaning agent for stainless steel. Always...

EN 15 Faults table If the appliance does not work properly, this does not always mean that it is defective. Try to deal with the problem yourself first by checking the points mentioned below in the table or contact the Asko service department (see guarantee card). FAULT CAUSE SOLUTION There is a sme...

EN 17 General This appliance should only be connected by authorised personnel. This appliance should be installed according to the requirements of the local authority. Caution! The type of gas and the country for which the appliance has been designed are indicated on the application identification c...

EN 18 Electrical connection 230 - 240V - 50Hz - 1.1 W The electrical connection must comply with national and local regulations. • Wall socket and plug must be accessible at all times. • If you want to make a fixed connection, ensure that a multi-pole switch with a distance between contacts of 3 mm ...

EN 19 Building in Preparing the hob Fit the elbow supplied on the appliance’s gas connection. 1/2” ISO 228 (straight) 1/2” EN 10226-1 (conical) Sealing ring Cut opening in worktop Cut the opening in the worktop. This should be done very accurately (see building in dimensions). If the woodtop is made...

EN 20 INSTALLATION Placing the sealing tape Remove the protective foil from the sealing tape (A) and apply the tape around the cut-out in the worktop. A

EN 21 INSTALLATION Building in dimensions Hg1654s 526 600 43 560 490 60 550 1* 1* 1* 1* G1/2’’ 20 600 480

EN 25 INSTALLATION Space to be left free around the appliance A hob generates heat. Leave a sufficient distance between the appliance and non heat-resistant materials. Take care also with materials that may discolour (such as stainless steel). Caution! The bottom of the hob becomes hot. Do not place...

EN 26 INSTALLATION Gas information ASKO Hg1774s - Hg1984s/a GAS BURNER INJECTOR INJECTOR ADJ. BURN GAS BURNER WOK SCREW RATE PRESSURE IN MM IN MM MJ/h kPa SIMMER 0.90 0.45 3.60 N.G. 2 x NORMAL 1.20 0.60 6.70 1.0 LARGE 1.35 0.65 8.50 WOK 1.80 3.00 1.16 14.90 SIMMER 0.48 0.30 2.90 ULPG* 2 x NORMAL 0.6...

EN 28 APPENDIX Disposal of packaging and appliance In the manufacturing of this appliance durable materials were used. Make sure to dispose of this equipment responsibly at the end of its lifecycle. Ask the authorities for more information regarding this. The appliance packaging is recyclable. The f...