Arkon TTGO136 - Manual
Arkon TTGO136 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
TTGO136 | Bendable Steel Swivel Dash / Console Mount for Tomtom GO Devices
CM021-SB-2
Consumer Hotline:
(USA) (800) 841-0884
(INT'L) (626) 254-9005
Mon-Fri. 9am-5pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Made in Taiwan
© Copyright 2007 Arkon Resources, Inc.
The Mobile Mounting Specialists
TM
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi
-
bility of liability for injury or death as a result of car crashes and/or
air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.
(G)
(H)
S
tep 1.
S
tep
2
.
Attach the adapter plate by sliding it up into the slot on the back
of the Tomtom GO 5
20
, 7
20
, 9
20
, or 9
20
T device.
Follow the step from
Pedestal Adjustment & Device Cradle
Attachment
above.
Instructions for APTTGO520 Adapter Plate
S
tep 1. Attach the device to the pedestal by inserting the dual T
-
tabs
(G)
of the pedestal into the T
-
slots of the adapter plate
(H)
.
for Tomtom GO 5
20
,
7
20
, 9
20
, and 9
20
T
APT TGO5
20
Removal of Dash
M
ount
To remove the dash mount completely, use a cotton swab dipped
in isopropyl alcohol.
S
imply peel up a corner of the dash mount
adhesive and swab under the pad while gently pulling until the
adhesive begins to release. Remove slowly. No damage will occur
from the adhesive if it has been properly installed and removed per
these instructions. You may see a slight discoloration between this
area and other parts of your dash due to fading caused by the sun.
S
tep 1.
S
tep
2
.
S
tep 3.
S
tep 4.
C
hoose the best location on vehicle to place the mount.
Do not place mount in or near an air bag deployment zone or
where it will obstruct view of the road.
C
lean off dash surface with alcohol cleaning pad and let dry.
(A)
Do not attempt application of the dash mount if the temperature
is below 68o F (
20
o
C
).
Remove paper liner from adhesive on base
(B)
and affix adhesive
to the dash. Let stand (at room temperature) for
2
4 hours before using.
Adjust the angle of the pedestal head by bending the flexible
metal strip
(C)
. Rotate the strip and tighten the base cap.
(D)
Pedestal Mounting
(B)
(A)
(C)
(D)
Pedestal Adjustment and Cradle Attachment
Compatible with:
t5PNUPN(05EFWJDFT
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
