Arkon SM210 - Manual

SM210 & CM910 Universal Windshield, Dash, Console and Vent PDA Mount

Consumer Hotline:
(USA) (800) 841-0884
(INT'L) (626) 254-9005
Mon-Fri. 9am-5pm, PST

www.arkon.com

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

The Mobile Mounting Specialists

TM

SM210

CM910

CM043-ST-2

CM043-ST

CM090

CM090-2

SM020

SM020-2

Safety Precautions

Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or
air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.

AP020

Step 1.

Step 2.

Locate a safe flat surface on the dash
or console to mount the pedestal.
Clean the dash with the alcohol pad
provided. Let the dash surface dry
before applying the adhesive disc (G).

Push the pedestal suction cup (A)
firmly to the disc (G). Flip the lever (B)
down to secure the suction cup.

Dash Installation

Step 1.

Step 2.

Step 3.

Step 4.

Pedestal Instructions

(A)

(C)

(F)

(D)

(B)

(G)

(A)

(B)

Push the pedestal suction cup (A) firmly to the windshield.
Flip the lever (B) down to secure the suction cup.

Adjust the angle of the pedestal head by using both hands to
bend the gooseneck (C).

Adjust the angle and rotation of the pedestal head by
loosening the swivel-tightening ring (D).

Attach the device cradle to the dual-T tab head (E) by
inserting the T-tabs into the T-slots (F).

(I)

(H)

(J)

Step 1.

Step 2.

Step 3.

Universal Cradle Instructions

If necessary, adjust the support legs
(J) by sliding them laterally. These
provide support for your device.

Place device on the support legs (J)
and squeeze the side grip arms (H)
until they fit securely to the device.

Push the release button (I) in order
to release the device from the cradle.

CM047-S

CM047-S2

CM043-ST-2

CM043-ST

AP020

CM047-S

CM047-S2

(E)

Flat side face up

Step 1.

Air Vent Pedestal Assembly

Step 1.

Gently insert vent clips into vent louvres until the mounting clips
are attached to the fin/blade of the vent. Adjust the support leg
(M) vertically until it rests firmly along the bottom of the vent or
dash surface below the vent.

Use caution when adjusting the swivel movement to avoid
damaging your air vents.

Insertion of Pedestal into the Air Vent

(K)

(M)

(L)

(N)

(O)

(L)

Step 1. Adjust the swivel angle of the

pedestal head by frimly
holding the back of the
pedestal (L), pulling out the
pedestal head and twisting to
the desired angle. Adjust the
lateral angle of the pedestal
head (N) by simply twising the
head on the pivot axis (O).

Pedestal Adjustment

Attach the vent mounting clips (A) to the back of the pedestal (B)
with the vent clips positioned with the flat sides facing up.