Arkon GN115-GN014 - Manual
Arkon GN115-GN014 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
5. Position the Nuvi as desired
WARNING:
Do not install Arkon products over an air bag cover or within the air bag
deployment zone. Arkon Resources, Inc. assumes no responsibility of liability
for injury or death as a result of car crashes and/or air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to your car,
your device, or yourself due to the installation or use of the pedestal mount.
!
1. Choose the best location on vehicle to place
the mount.
Do not place mount in or near an
air bag deployment zone or where it will
obstruct view of the road.
Travel Mount
TM
Windshield, Console, or Dash Mount for
Garmin Nuvi® and StreetPilot® portable GPS navigation
devices.
Compatible with ALL Garmin Nuvi portable navigation
devices including: Nuvi 200, 250, 270, 300, 310, 370,
600, 610, 650, 670, 680.
Compatible with Garmin StreetPilot models c310, c340,
c510, c530, c550, c580.
Installation for optional Console Dash Mount (GN115)
6. To remove, hold the pedestal with one hand
and firmly pull Nuvi away from pedestal with your
free hand.
Removal of Dash Mount
To remove the dash mount completely, use a cotton
swab dipped in isopropyl alcohol. Simply peel up a
corner of the dash mount adhesive and swab under the
pad while gently pulling until the adhesive begins to
release. Remove slowly. No damage will occur from
the adhesive if it has been properly installed and
removed per these instructions. You may see a slight
discoloration between this area and other parts of your
dash due to fading caused by the sun.
1. Remove paper liner from adhesive on mount disk
and affix adhesive to the dash. Let stand (at room
temperature) for 24 hours before using.
The Mobile Mounting Specialistsô
www.arkon.com
Arcadia, CA 91006 USA
Made in Taiwan
© Copyright 20
0
8
Arkon
Resources, Inc.
Consumer Hotline:
(USA) (
8
00)
8
41-0
88
4
(INTíL) (626) 254-9005
Mon-Fri. 9am-5pm, PST
2. Attach Nuvi to mount ball head by firmly pushing ball (A) into
socket on the back of the device (B) as pictured below.
4. Adjust the angle of the arm by loosening
the adjustment knob (E).
3. Push the pedestal suction cup (C) firmly to the
windshield. Flip the lever (D) toward base to secure
the suction cup.
(C)
(D)
(E)
(C)
(D)
(B)
360
o
swivel
(17mm ball head)
(17mm socket)
(A)
(B)
2. Push the pedestal suction cup (A) down onto the
disk (D). Flip the lever (B) down to secure the
suction cup. Adjust the angle of the arm by
loosening the adjustment knob (C). Poistion Nuvi as
desired.
(A)
GN115 - GN014
I Windshield Suction Mount for Garmin
TM
Nuvi®
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
