AMX RDM-SWM - Manual
AMX RDM-SWM – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Installation Sheet
RDM-SWM
Switch Module 2400 W
The RDM-SWM Switch Module is a 2400 W general purpose relay module
built for economical switching of incandescent lamps, low-voltage
transformers, switched fans and electrical outlets. It is designed for use with
the RDA series of enclosures, in an AMX Lighting™ modular digital
dimming system. The RDM-SWM uses a positive air gap type relay. This
module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.
RDM-SWM UL and C-UL Ratings
•
General purpose: 2400 W
•
Resistive: 2400 W
•
Ballast: 2400 W
•
Motor: 277 VAC, 1 hp
Suggested Switched Loads
•
Incandescent
•
Low-voltage
•
Motors
•
Switched outlets
•
Fluorescent
Specifications
•
Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)
•
Non-phase dependant
•
Use wires rated at 75°C (167°F)
•
Torque terminals to 7 in-lbs. (0.8 N/M)
•
Max. wire size: 10 AWG (4 mm²)
•
Wire stripping length: 0.28" (7 mm)
•
Weight: 0.5 lbs. (0.227 kg)
•
BTU/hr: 5
•
Control current: 85 mA @ 12 VDC
Caution: Pre-Installation Notes
•
All Class 1 wiring must be connected to proper terminals.
•
All control wiring must be connected to proper terminals.
•
Disconnect power while installing or connecting the unit.
•
Keep top and bottom air vents clear at all times.
•
Test loads for shorts before connecting.
•
Use low-voltage wires with a 300 volt rating or greater.
•
Use field installed copper conductors.
•
All electrical ratings are for continuous duty.
•
For indoor use only.
•
This module may require extra power from the AXlink connection or an
external power supply connected to the control card.
Connecting the RDM-SWM to the AMX Lighting Master
FIG. 1
RDM-SWM Switch Module
Relay A
Line in (hot)
Load out
Mounting
points
Low-voltage control wiring:
4-pin connector to AMX
Lighting master controller
High-voltage
connections
FIG. 2
RDM-SWM connections
Pin 4 (GND)
Pin 3 (RLY)
Pin 2 (DIM)
Pin 1 (+12 V)
3 (-)
1 (+)
RDM-SWM 4-pin module connector
4-pin plug from RDM series module
NOTE: The 4-pin plugs from the module connector to
the 4-pin connector on the master (black plug cover facing up).
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
