AMX HD-RD - Manual
AMX HD-RD – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Multigang Installations; Installation; for copper wire only; Large; Mounting Diagram
- Page 3 – Wiring Diagram 2; Wiring Diagram 1
- Page 4 – Wiring Diagram 3; Wiring Diagram 5
- Page 5 – Tapswitch; Tapswitch; Remote Dimmer Operation
- Page 6 – Troubleshooting Guide; Symptom
- Page 8 – If you need assistance, call the toll-free
1
Please Read Before Installing
Installation Instructions
HD-RD
HD-RS
Overview
The HD-RD Remote Dimmer and the HD-RS Remote
Switch are for use with
HomeWorks Maestro
Dimmers and
Switches.
Up to nine HD-RD Remote Dimmers may be used with a
HomeWorks
Wired or RF
Maestro
Dimmer, and up to nine
HD-RS Remote Switches may be used with a
HomeWorks
Wired or RF
Maestro
Switch.
Important Notes
Codes:
Install in accordance with all local and national elec-
trical codes.
Danger:
These controls must not be used to con-
trol equipment which is not visible from every con-
trol location. They must also not be used to con-
trol equipment which could create hazardous situ-
ations such as entrapment if operated accidentally.
Examples of such equipment which must not be operated
by these controls include (but are not limited to) motorized
gates, garage doors, industrial doors, microwave ovens,
heating pads, etc. It is the installer’s responsibility to ensure
that the equipment being controlled is visible from every
control location and that only suitable equipment is connect-
ed to these controls.
Overheat Damage:
To reduce the risk of overheating and
possibly damaging other equipment, do not install
to control receptacles or motor-operated appliances.
Environment:
Ambient operating temperature:
0-40°C, 32-104°F, 0-90% humidity, non-condensing. Indoor
use only.
Spacing:
If mounting one control above another, leave at
least 4 1/2" (114mm) vertical space between them.
Wallplates:
Lutron Claro
®
and Satin Colors
TM
wallplates are
recommended for best color match and aesthetic appear-
ance. Do not paint controls or wallplates.
Cleaning:
To clean, wipe with a clean damp cloth.
DO NOT
use any chemical cleaning solutions.
Wallboxes:
Lutron recommends using 3-1/2" (89mm) deep
wallboxes for easier installation. Several controls may be
installed in one multigang wallbox - see Multigang
Installations (page 2).
Remotes:
Use only Lutron
®
HomeWorks Maestro
Remote
Dimmers (HD-RD) with HRD/HWD-6D, -6ND, -10D, -10ND,
and -5NE controls. Use only
Lutron HomeWorks Maestro
Remote Switches (HD-RS) with HRD/HWD-8ANS controls.
Up to 9 HD-RD or HD-RS controls may be used with a
HomeWorks Maestro
Dimmer or Switch. Mechanical 3- or 4-
way switches will not work.
Designer-Style Maestro
®
Remotes
HD-RD, -RS
120/127 V ~, 50/60 Hz
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Multigang Installations In multigang installations, several controls are grouped hori-zontally in one multigang wallbox. • No derating is required for Remotes. • When ganging Remotes with dimmers or switches in the same wallbox, derating is required for the dimmers orswitches. See the installation...
3 Multi-Location Installation 1 -6D, -10D with HD-RD 120/127VAC50/60Hz Black Green Hot Neutral Red Blue Black Green Red Blue Black Green Red Blue LightingLoad Multi-Location Installation with Neutral 1, 2 -6ND, -10ND, -5NE with HD-RD, -8ANS with HD-RS Wiring Diagram 2 Remote Dimmer Dimmer 120/127VAC...
4 DIM HO T OUT HO T IN CO N T R O L NEUTR AL 120/127VAC50/60 Hz Dimmer Red Black Blue Green Hot/Live Neutral Lighting Load NGRX-PB or ELVI-1000 DIM HO T OUT HO T IN CO N T R O L NEUTRAL SW HO T 120/127VAC50/60 Hz Dimmer Red Black Blue Green Hot/Live Neutral Lutron ® Hi-lume ® Fluorescent Dimming Bal...
