AMX DAS-AMFM - Manual

Installation Guide

DAS-AMFM

AM/FM Tuner Module

Overview

Add AM/FM Radio functionality to your Mi Series system with the
DAS-AMFM AM/FM Tuner Module (

FG1110-01

).

• Up to two DAS-AMFM modules can be added to each Mi Series

controller.

• Each tuner module uses one source input on the audio controller.

WARNING

: Disconnect all power sources before opening the chassis. Fail-

ure to disconnect power before performing this installation may cause injury
or death.

CAUTION

: Make sure to discharge all static electricity from your body

before touching any components of the tuner modules or the audio control-
ler. Failure to do so may lead to permanent damage to the tuner or
controller.

Single Tuner Installation Instructions

Installing The Tuner Module in the Controller

1.

Remove the cover from the controller.

2.

With the back of the unit facing you, remove the screws from the
Tuner Option cover plate at the right top corner of the rear panel
(FIG. 1) and remove the plate. Retain the screws, as they will be used
to install the tuner.

3.

Carefully insert the DAS-AMFM tuner module into the controller, with
the electronics facing up, and use the screws that attached the Tuner
Option cover plate to secure the tuner to the controller.

Note

: Be careful not to damage the white ribbon cable on the top of

the Tuner module.

4.

Place the Rear Panel connector at the end of the ribbon cable (FIG. 2)
on the rear board pin-bus, keeping the red stripe at the top.

5.

Connect the "

Tuner 1

" connector on the ribbon cable to the Tuner 1

module (FIG. 3).

Note

: The ribbon cable must be oriented so that the red stripe is con-

nected to Pin 1 on the connector.

• Be sure that both ends of the cable are securely plugged into their

respective boards through the 20-pin connectors (FIG. 4).

Setting the Jumpers in the Controller

Examine the configuration of the jumpers on the left end of the rear board,
as seen when viewing the rear board from the front of the controller.
The jumpers should be in the “Off” position, with the top pair of pins in each
configuration exposed and the jumpers connecting the second and third set
of pins.
Move the top set of jumpers to the “On” position, connecting the first two
sets of pins and leaving the third set exposed (FIG. 5).

• Reconnect power to the unit and turn it on to make sure that the tuner

is properly integrated with the controller.

• If the tuner is functioning properly, remove power and replace the unit

cover.

FIG. 1

Rear Panel Tuner with Tuner Option cover plate

FIG. 2

Tuner Ribbon Cable

Tuner 1 (installed)

Tuner Option
cover plate

Tuner 2

Tuner 1

Rear Panel

RED STRIPE (to Pin 1)

not used

FIG. 3

Tuner 1 Module Connection

FIG. 4

20-Pin Connector and Ribbon Cable

FIG. 5

Controller Jumper Configuration

Tuner 1 Connector

Rear of controller

Tuner 1 jumpers (in “On” position)

Tuner 2 jumpers (in “Off” position)

Exposed pair of pins