American Standard 710007-100 - Manual
American Standard 710007-100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION PROCEDURES:; OPPOSITE
- Page 3 – DOOR
- Page 4 – ADJUSTMENT RAIL MOUNTING SCREW; Caulk where threshold meets base on outside of unit only.
- Page 6 – GARANTÍA LIMITADA DE POR VIDA DE; comprador original; Esta garantía limitada NO CUBRE lo siguiente:; WARRANTY FOR SHOWER DOORS; original consumer purchaser; This limited warranty DOES NOT COVER the following:
1
Owner’s Manual
PIVOT SHOWER DOORS
Thank you for selecting our product...the benchmark of fine quality for over 100 years. To ensure that your installation
proceeds smoothly--please read these instructions carefully before you begin.
7 1 0 0 0 7 - 1 0 0
BEFORE YOU BEGIN...
Local building codes vary by location. Observe all local plumbing and building codes.
Unpack your new shower doors and inspect them carefully for damage. Verify that the doors are the correct size for your installation.
TOOLS & MATERIALS REQUIRED...
• Tape Measure • Electric Drill • Level • Phillips and Flat Screwdrivers • Drill Bits 1/8" & 3/16" • Hacksaw • Silicone Caulk
IMPORTANT
: Record the Model No. (see carton) of your shower or tub enclosure for future reference. Model No. ____________
READ THE INSTRUCTIONS CAREFULLY
: Familiarize yourself with all the parts as shown in the exploded view. The exploded view
will also provide a helpful reference when relating the location of the various parts and how they are mounted.
22
18
19
8
21
6
12
13
11
23
5
3
15
4
14
22
10
9
24
16
20
17
7
1
Record Model Number _______________
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
7 1 0 0 0 7 - 1 0 0 2 1 3 INSTALLATION PROCEDURES: Determine side at which the door will pivot (left or right).The pivot side should be opposite the showerhead. Measure width of the opening at the centerline of bottom. NOTE: This door swings out only. Verify door will clear any obstructions before i...
7 1 0 0 0 7 - 1 0 0 3 On side opposite pivot jamb, drill a 1/8" hole in threshold located 5/8" from wall and 7/8" from flat edge of threshold. Fasten positioning spacer to threshold using one #8 x 1" pan head screw. For doors with narrow strikes (e.g. Model #804NS) position-ing space...
7 1 0 0 0 7 - 1 0 0 4 13 Place magnetic jamb over adjustment rail with magnetic strip facing to outside of shower. Close door and adjust magnetic jamb to allow 1/8" to 1/4" clearance between magnetic jamb and door panel. NOTE: If magnets repel each other, remove and reverse. To adjust magnet...
