Amana WS900E - Manual
Amana WS900E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 1 - Wall Sleeve Dimensions; Table 1; KIT ACCESSORIES; Figure 2 - Minimum Wall Opening Dimensions; Figure 3 - Minimum Unit Clearances
- Page 3 – PRE-INSTALLATION CONSIDERATIONS; Figure 5 - Framing with Lintel; Figure 6 - Block and Brick Veneer; Sleeve; Figure 7- Sleeve Stiffener Remova; Figure 8 - Rear Enclosure Panel; Do not use the wall sleeve as a lintel.; See
- Page 4 – Figure 9 - Panel Removal; WALL SLEEVE INSTALLATION; Figure 10 - Wall Sleeve Attachment to Opening; Caulk or seal around the outside of the entire sleeve.
The wall sleeve must be installed before the air conditioner or heat pump chassis can be
set in place. Read the instructions thoroughly before proceeding.
Made in USA
Contents
KIT ACCESSORIES ..................................................................................................... 2
D
RAIN
K
IT
....................................................................................................... 2
S
UBBASE
, L
EVELING
L
EGS
, M
AIN
D
UCT
,
AND
H
YDRONIC
H
EAT
K
ITS
........................ 2
PRE-INSTALLATION CONSIDERATIONS .................................................................. 3
O
UTDOOR
E
NCLOSURE
P
ANEL
R
EMOVAL
.............................................................. 3
WALL SLEEVE INSTALLATION .................................................................................. 4
PTAC W
ALL
S
LEEVE
I
NSTALLATION
I
NSTRUCTIONS
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer. This
includes all safety precautions and related items.
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special
attention to all safety warnings. Often during installation or repair it is possible to place yourself in a
position which is more hazardous than when the unit is in operation.
Remember, it is
your
responsibility to install the product safely and to know it well enough to be able to
instruct a customer in its safe use.
Safety is a matter of common sense...a matter of thinking before acting. Most dealers have a list of
specific good safety practices...follow them.
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual, the
precautions listed here take precedence.
Part No. A3495105
Printed in USA
August 2005
When 230/208 volt units are to be installed, the power
supply may be either cord connected or permanent
wiring. Permanent wiring may be done through the hard
wire junction box, or the accessory subbase.
When 265 volt units are to be installed, the power supply
must be permanent wiring. Permanent wiring may be
done through the accessory hard wire junction box, or
the accessory subbase.
An exposed cord connection
on 265 volt units is not permitted.
The subbase accessory includes leveling legs. If added
wall sleeve support is required and the subbase is not to
be used an accessory leveling leg kit may be installed.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Amana WS900E
Summary
2 D RAIN K IT An indoor/outdoor drain kit is available as an accessoryitem. When a drain kit is to be installed, do so beforeinstalling the wall sleeve in the wall. See the drain kit foractual installation instructions. S UBBASE , L EVELING L EGS , M AIN D UCT , AND H YDRONIC H EAT K ITS Installatio...
3 Before proceeding with the sleeve installation, ensure the following guidelines for locating the wall opening and sleeveare met: PRE-INSTALLATION CONSIDERATIONS WoodFrame Lintel Figure 5 - Framing with Lintel SteelLintel Caulk Top,Bottom, andBoth Sides 1/4"6 mmMinimumProjection ConcreteLintel ...
4 Figure 9 - Panel Removal WALL SLEEVE INSTALLATION After the wall opening is checked and approved for location, size, and clearances, complete the following to install thewall sleeve. 1. Remove the outside enclosure panel from the wallsleeve. 2. Slide the wall sleeve into the wall opening. Do not d...
