AEG L6FBI941N- User Manual

3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Use a cutter to cut through external film. 2. Remove the external film. 3. Remove the cardboard top and the polystyrene packaging materials. 4. Open the door and remove ...

20 O 20 O 45 O 45 O Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use ...

4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5. Without the plastic hose guide: Put the drain hose in the spigot and tighten it with a clip. Refer to the illustration. Make sure that the drain hose makes a loop to prevent particles ...

1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for levelling the appliance 8 Drain hose 9 Inlet hose connection 10 Mains cable 11 Transit bolts 12 Hose support 5. CONTROL PANEL 5.1 Control panel description CottonsCotton EcoSyntheticsDelicates...

5.2 Display A B E D C A The digital indicator can show:• Programme duration (e. g. ). • Delay time (e. g. or ). • Cycle end ( ).• Warning code ( ). B Extra rinse indicator. It lights on when this option is se-lected . C The indicator blink during the laundry load detec- tions. D Child safety lock in...

6.3 Temp. When you select a washing programme, the appliance automatically proposes a default temperature.Set this option to change the default temperature. The indicator = cold water of the set temperature comes on (the appliance does not heat the water). 6.4 Spin When you set a programme, the appl...

Touch this button once to decrease the duration.In case of smaller load, touch this button twice to set an extra quick programme. The indicator of the option and the indicator of the set value are on. 6.8 Start/Pause Touch the Start/Pause button to start, pause the appliance or interrupt a running p...

7.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the g...

10. DAILY USE WARNING! Refer to Safety chapters. 10.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the On/Off button for a few seconds to activate the appliance. A short tune sounds (if activated). The programme dial is automatically set on ...

1 2 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set ...

If the ProSense phase is already carried out and the water filling is already started, the new programme starts without repeating the ProSense phase . The water and the detergent are not drained out in order to avoid waste. 10.11 Opening the door If the temperature and level of the water in the drum...

• After 5 minutes from the end of the washing programme Press the On/Off button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by functio...

11.4 Ecological hints • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains, you can use a stain remover when you set a programme with a low temperature. • To use the co...

45° 20° 12.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump. 12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° ...

WARNING! Deactivate the appliance before carrying out any check. 13.2 Possible failures Problem Possible solution The programme doesnot start. Make sure that the mains plug is connected to the mains sock-et. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in t...

Problem Possible solution Too much foam in thedrum during the washingcycle. Reduce the quantity of detergent. After the washing cycle,there are some deter-gent residues in the dis-penser drawer. Make sure that the flap is in the correct position (UP for pow-der detergent - DOWN for liquid detergent)...

Programmes Load(kg) Energyconsump-tion (kWh) Waterconsump-tion (litre) Approxi-mate pro-grammeduration(minutes) Remain-ing mois-ture (%) 1) Standard 40°C cotton 4,5 0,61 44 205 52 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.30 0.30 The information given in the chart above is complia...

16. ACCESSORIES 16.1 Available in www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. 16.2 Fixing plate kit If you install the appliance on a plinth, secure...